Printable View
heya guys.. i have a honda civic turbo running a wolf3d ver4
i just got an rsm and im having trouble locating the SPEED SIGNAL wire from the ecu..
ive found 12v+,ground,RPM but cant find speed signal
here is a diagram i got from the wolf3d website
help!
http://photos.friendster.com/photos/...822056284l.jpg
Hey Paulo lol since when did you get a civic? I thought you hated hondas.. :p
I assume its a EG civic OBD1
On a OBD1 wiring setup the Vehicle Speed Sensor wire is the one your after (B10) refer to the diagram below
RSM Manual
http://members.datafast.net.au/~teet...sm_diagram.jpg
http://members.datafast.net.au/~teet...OBD2to1ab2.jpg
i just realised the wolf3d does not has speed signal output
so i have no idea where to get it from
anyone know where i can start looking?
back of the dash would be a good starting point
:thumbsup:Quote:
Originally Posted by Jomsy
Yep, tap it from the instrument cluster harness.
why go through all that trouble riping out the cluster to get to that wire when you can easily access the VSS wire at the ECU plug? Unless your factory ECU plugs have been choped up?
You don't have to pull the cluster to get to the dash harness in an EG. Just pull the trim panel under the steering wheel, 2 screws, takes 30sec. :)Quote:
Originally Posted by Bowzer
got it from the old ecu wiring! found it all tied up in a corner
Now i have another problem! everything lights up
but after the apexi logo the screen goes blank!
i think i have been sold a dodge unit
so i was wondering if anyone knows where i can get the monitor unit fixed
some electricall engineeer maybe
which version of the wolf did you get? cos i was pretty sure it has the speed sensor cos i had a wolf3d v3.11 and that was an older unit.
Well considering all the other wires he needs access to are within close proximity of the ECU be better to route the wire to the ECU plugs, and as for the the trim under the steering wheel its pretty messy there...Quote:
Originally Posted by PhatSol
Meh, could say the same for the other end too. Should not be messy under there unless the wiring has been tampered with (eg, dodgey alarm install). All depends where you mount the RSM. On the pillar, no point running wires from the other side of the car (ecu)...Quote:
Originally Posted by Bowzer
saw ur car on sunshine ave today paulo :D
yoo asiansquad
who are you'?
anyone here know anyone that can repair apexi avcrs
my monitor is broken
=[
Unless your using the RSM for wank value then i guess what ever method works will be fine...Quote:
Originally Posted by PhatSol
Most installs ive done for a RSM on jap cars are to remove the 180km speed cut + wank value :rolleyes:
RONALDQuote:
Originally Posted by paulosportz
yooo ronald!!!
know anyone that can repair aexi avcr's
or can u hook me up with a second hand one?