[Euro/7thAccord] Window Auto-up via remote, DIY solution!
Finally there is an affordable solution for those who dont want to install an expensive alarm, and are willing to pay roughly $100 for a simple DIY add-on to make the windows roll up with two clicks of the Lock button on the remote.
The HM20 Module wires into the drivers door by tapping into 5 existing wires, and fools the car by mimmicking the door key-hold function to wind up the windows.
Buy an "HM20" Window Roll-up Module from kptechnologies in the US. $US60+shipping, so its around ~$AU100 for us
http://www.kptechnologies.com/
Here are some clear instructions with photos:
http://www.tsxclub.com/forums/showthread.php?t=10206
And more instructions/info:
http://kptechnologies.com/forums/viewforum.php?f=14
ps. It should work for the normal 7th Gen Accord too!
:thumbsup:
kptechnologies one touch sunroof
I bought the window roll up and sunroof controller from kptechnologies, my sunroof module is DOA i think, emailed the company to find out but mine came missing the orange wire for the vent function so might have been sent an incorrect unit and thats why it didnt work after install.
My idea with this was to connect the sunroof module to perm power instead of ignition power (yellow wire on sunroof module) and then use a relay to interface the lock signal wire from the window roll up module to the sunroof module (SPST - lock signal for sense and switching to the close wire). This would suffice to allow the sunroof to close and all windows to roll up on a double press of the keyfob. Also would cause the one touch sunroof to operate without the ignition on as a side effect but that is not to bad i think.
Once i sort out this sunroof module ill install it all...
This should work right? positive pulse from lock signal interfaced using the relay to allow the ground switching of the sunroof??