Printable View
Q.1 -I got myself a AUDM 'Type R' Manifold which i will be bolting to a DC4 ( GSI ) Integra. My question is has anyone done this/ know - If the manfold will bolt straight up to the cat ? ( donut size / Flange angles e.t.c ) as i've heard it might not ? I know it bolts to the block fine, worried about the Cat section ?
Q.2 - Does anyone know what the actual size of the GSI stock exhaust piping is, im pretty sure its same as VTIR - Which from what i can see looks like 2 " ?
its the same length etc but MAYBE the 2 bolts on teh flange maybe alittle offset.
2.25" on the stock GSR but I could be wrong. I never measured mine before I went to 2.5" but I remember someone elsewhere saying 2.25".
Hmm ok, well i suppose i'll just get under the car when i get a chance and TRY have a look and see how it sits, otherwise i'll just have to get a pipe welded from the cat to fit the manifold...**Hope it just bolts up though** MUCH EASIER...
I think.
GSI is 2inch or 1.75, VTIR is 2inch. AUDM type R header is 2.25 i believe. Therefore it wont bolt straight on, but anyone with some welding experience should be able to connect it..
My numbers might be wrong, but definately GSI header and Type R header are different size.
Did you end up getting it put on???
Nah man didnt have time with fathersday and all.. Might give it a shot tonite..
Felix - I know the headers (Runners)are different design/size however im pretty sure 2-1 Section that bolts up to the cat are the same size ( from what i can see anyway )...
Nah they should be different. They might look the same size.Quote:
Originally Posted by Andrew21
A pipe with a diameter of 2inch and a pipe with a diameter of 2.25/2.5 inch will look allmost the same to the naked eye, unless you put them side by side.
it wont bolt up the flanges dont line up..
Trust me ive had a ITR manifold fitted to my GSi
Locote - Is that because the flange is on a angle... ?
Therefore all would be require is to cut the flange off the cat , fit to header at right angle, then re-weld back on to cat ?
i planning on doing this very soon ...it will fit but needs to be welded is this correct???
by manifold u guys mean headers rite??
please help
Yes that is correct...
got it all fitted today - hi tech products
from headers back 2.5" piping all the way through 4" muffler
sounds crazy gettin silencer for it but power wise improvement
2.25 on the stock gsr is correct.Quote:
Originally Posted by Slow96GSR