[DIY] Headrest Screen install FD civic
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: to fit OA 5" screen to headrest
Required: razor blade, marker, screen, zip ties, drill, " dremil tool "
Steps:
1: I already have had done one.. so im coping that... first mark out the for the screen cradle to fit.. in my case in the same spot as the last one
http://img527.imageshack.us/img527/556/94679345xl9.jpg
http://img61.imageshack.us/img61/9348/71561970lh4.jpg
2: Now u have marked it out.. grab a brand new razor blade and cut out inside the lines you have marked. then peel off the material ( it will be glued to a 5 mm layer of foam.. peel off the lot
http://img61.imageshack.us/img61/1787/69557353kj1.jpg
http://img150.imageshack.us/img150/5454/13133130be3.jpg
3: cut out about 30 - 40 mm of foam for the screen to fit in... if your not sure.. trial and error slowly get deeper
http://img482.imageshack.us/img482/6402/75730205af6.jpg
http://img142.imageshack.us/img142/9333/28623388vk4.jpg
4: Now cut out more foam.. to get the ends down to the polls... as wires have to go through them and the screen is fastened to them
http://img482.imageshack.us/img482/9127/29157743aq2.jpg
5: Fit the cradle and screen to make sure it will all fit with wiring behind it.. if it dont fit take out more foam..
http://img53.imageshack.us/img53/4835/28203145hf0.jpg
6: place zip ties around the polls. leave them open read to secure the cradle for the screen
http://img53.imageshack.us/img53/6210/88333151aq6.jpg
7: Cut the little pins off the back of the cradle.. to give roam for the bulky part of the zip tie to get through
http://img257.imageshack.us/img257/1055/10cj0.jpg
http://img167.imageshack.us/img167/2504/11ab6.jpg
8: " the tricky part " ok now u need to drill a hole in the poll to poke the wire through use a center punch to put a dent in the poll for a place to start drilling... ( you will see why its the tricky bit lol )
9: once the hole is done.. put the screen wire through the cradle and run the wire down the poll...
10: leaving the wire though the cradle but with the screen out zip tie the cradle down to the head rest.. slowing pulling each corner tighter until u get what u want..
http://img73.imageshack.us/img73/2963/12gy6.jpg
11: once it is where u want it push the screen into the cradle and your done
Comments :
have not run the cableing through the seet yet but i will post up if i have any troubles doing so... but its pretty strate forward
The car i have done this to is a new 2007 civic..
Also not all screens have the same cradle and screen setup.. but i found the option Audio screens to be the best design... also the screen qual is second to none..
Thanks guys
i hope your projects go well