dead ECU dude,
or poor wiring, but more dead ECU
Printable View
dead ECU dude,
or poor wiring, but more dead ECU
Could be poor wiring. it was a massive DIY re-wire, so i'll go through and recheck all that first, from beginning to end.
would a dead ECU be a cause for the main relay to not operate properly, because i've checked the wiring for that, and fixed it all up, but its still no good.
if it were factory wiring,then ECUMAN prob right,but it your case prob more wiring fault,u should post some more details with question next time.
if dead main relay then u prob have no ignition power to ECU,check & see if ign power before & after main relay when key on first.
Any idea on flashing EPS signals on a '99 S2000?
I got 22...
code 22 is
excessive change in vehicle speed sensor signal
or
a problem with average for vehicle speed and engine speed
basicly if you have been reving the car higher than 2000rpm for longer than 3 min and the vehicle speed is less than 1KM/h you will get code 22,
reset your EPS ECU and if the problem comes back you have to check the rear WSS signal to the EPS ECU
Need help ASAP.
I have a code 15 IOS - Ignition Output Signal
I think I fried my ICM.Help,is this the case?
Here!
Just want to contribute:
ej8 scs connector is next to fuse box.
http://img39.imageshack.us/img39/510...connector1.jpg
http://img40.imageshack.us/img40/755...connector2.jpg
Code #36 on P30 ecu for traction control, just thought I'd throw it up there if anyone gets it on their B16A :p
Good write up :)
I have an EK4 and there is a seperate set of fault codes for the ABS computer which gets put out at the same time.
Does anybody have these ABS fault codes handy?
Thanks
hey john
My first time working on Obd0 cars.
If the the LED from ecu blinks, does the Mil light blinks with it?
The LED from Ecu blinks but the Mil light is solid. Any help would be great
MIL is not ment to blink with the LED for faults,
only go by the LED in the ECU for codes
oh ok, car im currently working on, the led doesn't blink but the MIL remains on.
Main rely was changed recently if that helps