my dc5s have some problem with the washer reservior
the reservoir is empty btu when i try to refill it, its full after pouring some amount of water in. Then when i try the washer and after a few tries, its empty againn
soo whats the problemm??
thxx
Printable View
my dc5s have some problem with the washer reservior
the reservoir is empty btu when i try to refill it, its full after pouring some amount of water in. Then when i try the washer and after a few tries, its empty againn
soo whats the problemm??
thxx
a leak maybe?
dun think its leaking cuz i tried it straight away after refill it
and no water underneath the car
leak in the lines?
have you check that maybe the line is not connected properly to the nozzle. or missing the plastic connector (which is used to connect the two hoses to the nozzle)
May be the washer reservior has been clogged. Try to put garden water hose into down bottom of it and turn on water for a few minutes to flush out all the dirty stuff.
maybe you need to fill it up and let it sit for alittle for the water to sink in and then fill it up again. in saying this if this is the case you have a blockage somewhere.
i have the same problem with my DC2 vti-r i would fill it up to the top use it once straight after and then the water is gone.......no leaks on floor naffing
(its magic......lol)
thats the problem!! =PQuote:
Originally Posted by VTI-RRR
i might as well take it back to honda
mine is blocked after i let it run too low. anything i can add to unblock?
maybe it all ended up on ur windscreen?
i dunt know how much water it holds but i would guess not much.
sld be more then 100ml rite? lol thats how much i can fill in