Search:

Hey guys we finally found the problem.
It was the timing belt, it was half a tooth out.
Thanks heaps dorkin credit to you and thanks to all the other guys that gave me advice too
Car drives great...

Yea i will get a hondata as soin as i get it running properly
The only problem Is there is no 1 in adelaide to tune it so i will have to drive to melbourne to get it tuned

Hey all thanks for all your advice
Will check the map sensors on the weekend

ok will do
thanks dorikin will let u no how it goes

ok will do
thanks dorikin will let u no how it goes

hey all i need some urgent help
i have just completed a b18c7 conversion in to my ek4 civic
i have replaced timing belt,water pump,new clutch,plugs,leads
i have a problem with idling problem, the...

Hey I'm interested in 2ozhonda hoodies in xl are they still available?

thanks trism

hey all just a quick question
when i idle at the lights i can hear my pod sucking air is this ok?

hey guys i ended up getting some circuit 10s with a 30 offset.
thanks for all the help im happy with the 30offset im also using a 5mm spacer which
the wheels now sits pretty nice in my opinion....

just a quick question.
im thinking of getting some diffrent rims on my ek,
they are 16x8 with 0 offset. just wondering how much would it stick out of the guards
cause its my daily

yea it wont be to bad hopefully i dont get into to much trouble.
i just rebuilt my b16 around 4months ago its the oridginal engine with my car which has done 150k its still heaps strong atm but cant...

i got mine for 5k cant wait till it arives i got it through a mob in qld.
we should have a ozhonda meet up some time soon so i can check out your ride
i havent seen it around

thats a really good thread buddy.its great to see south aussie doing a thead.
im from the northern end i own an ek4 just about to do a b18cr conversion.
waiting for half cut to arrive, love wat you...

i will post up pic as soon as the half cut gets here
me and my friend will be doing it in my garage lol
im looking around for clutch atm
any suggestions any1 and also should i just machine my...

thanks all yea i prefer to do it my self rather than having a dc2.
i have just made payment for the half cut this morning so shouldnt be long before its in.
im going to refresh the motor before i...

thanks drgtr i got a half cut coming from japan which cost me 5000.

hey all just a quick question. ive got a ek with a b16a2, im looking for a b18c7
engine swap. how much power diffrence would i gain?

thanks heaps greddy
i hope i dont need to rewire anything.
would the itr ecu plug straight in or do i need to change the plug?

Hey all its been along time since been on here.
just need some help, would a b16a2 wiring loom and b18cr loom the same
cause ive just purchased a b18cr engine without loom but i got the ecu?

i...

hey all im from adelaide and im after a set of 16in rims for my ek4.
i also need some advice on some rims with a low off set to clear my brakes
i was wondering wheres the best place to buy them....

thanks guys much appreciated

oh and mike15 my friend gave me some spoon header already just didnt no if it would fit
but thanks for the offer

hi all
was wondering if the headers of a b18c would fit on to a b16a2 in a ek4


thanks

hey are you intrested in selling your turbo setup

my car got dynoed again today and it got 88kw atw and 208nm of torque.

hopefully that is correct