Search:

turn the sleeve upside down theres fresh thread at the top

if u care for the car change both i see it like changing 1 Tyre at a time yeah its cheaper on the wallet but the other Tyre will wear out soon anyway its no a necessity at the moment but when it...

rear mount HATE LIFE! take the T bracket out with the mount makes it a lil easier

they have probably used an eg/dc t bracket for the rear if that torque mount doest line up theres no way that either of the side mounts do either

work in progress

which james?

http://www.20somethingawesome.com/wp-content/uploads/2011/10/simpson_glove_slap-300x220.jpg

they are a 2piece taperd bush push the crushtube out then pry the bushes out i usualy shave the crush tube shorter so the washer forces the bush into the rack before the bolt tightens on the tube it...

what caused the cat to block up is probably what made it go bang lean mixture too much heat
too many variables to guess correctly

all head bolts that are (tty) torque to yield are a double hex head
i reuse most on hondas after i inspect them
compare length- a stretched bolt will be longer
pitting-any corrosion on the thread...

JAMES here;
the issue was a 10mm bolt caught in the vents of the brake rotor jamming between the carrier
i go to extreme lengths to keep my customers happy, as part of being compassionate about...

engine james middle_name_james mocchi naughty_james noise thak_thak vibration
View Tag Cloud

GU357 right on this one
ill give you rep when i have as many green ones as you!

bring it back ill move the perch up or swap the kings for the oem and put shorted front springs in the rear for that stiff feeling
i dont think the king springs are a good choice but the shocks are...

callipers might be warped discs who knows every time i jump in a customers car the noises just dissapear does my head!

check the purge line is connected to the top of the throttle body and not blocked and check the actuator vacuum from the back of the I/M is connected

check the cel code to start with then i can point u in the right direction

FOOL PROOF WAY- tapperd 12mm bolt that bolts the A/C to the bracket if that bolt is too long and u can get swing on the hammer ull find another 12mm bolt that goes thru the bracket and tensions your...

buy dear cry once buy cheap cry all the time id love to help but have 5 belts to do in 4 days fk it might js go to mexico or sumshit

be sure to change idlers seals and water pump any of these...

make sure u have washers that fit properly on the bottom linkage so u tighten the bolt agianst the bearing/bush and not on the actual gearstick
dnt just loosen it off

unless u drained the the ram that jack all is enough belive me

buy dear cry once buy cheap cry all the time id love to help but have 5 belts to do in 4 days fk it might js go to mexico or sumshit

be sure to change idlers seals and water pump any of these...

buy dear cry once buy cheap cry all the time id love to help but have 5 belts to do in 4 days fk it might js go to mexico or sumshit

be sure to change idlers seals and water pump any of these...

buy dear cry once buy cheap cry all the time id love to help but have 5 belts to do in 4 days fk it might js go to mexico or sumshit

be sure to change idlers seals and water pump any of these...

.007 nd .008 in inches