Search:

EF6/EF7/EF8/ED9 88-91 Seats and rails are all interchangeable!

Japan Honda calls it a Moonroof!

Top radiator hose : 19501-PW0-000
Bottom radiator hose : 19502-PW0-000

If you need any more part numbers (front bushes) let me know as i have the EPC for the EF9.

Most of the dealers dont have a clue about imports and CBF searching for part numbers, much easier to...

ED tie rod ends are longer than EF8-9, you could always cut down ED ones to suit. The part numbers i have for my EF8 which is the same as EF9 are:

53540-SH3-N11
53560-SH3-N11

Not sure what...

Hi Guys, i have an error code 20 on one of my EF8's and cannot for the life of me work out the solution. I've done some research and found that code 20 is the ELD electronic load detector and that it...

more than likely the main relay, common problem.

http://www.marklamond.co.uk/tech-honda/pgm-fi/main-relay/main-relay.htm

http://www.crxaustralia.com/forum/showthread.php?t=2902

Glad to help man!

Here is a write up on how to install them.

http://www.hondacrx.co.uk/faq/mirrors/

If it's a JDM EF it doesn't matter what year it is they all came with eyelet type.

EF7/8/9 all have the same rear lower control arm, so no need to change them if your fitting EF8/9 suspension.

here you go STTICH, i'll stick it in here in case qstoria or anyone else needs it.

Here is the part number for the EF8...

Yes $40 from honda. The 2 solenoid part numbers that i gave you will definitely fit yours as you have the same engine as me!

I replaced the 2 solenoid gaskets, not cheap though... about $40 total.

Do you mean the Cam end plug?

Here are some B16A1 part numbers:

Head gasket - 12341-PR3-000
Spark plug donuts - 12342-PR3-000
Cam end plug - 12513-PH5-003
Vtec solenoid A - 15825-PR3-005...

Yeh man something doesn't add up because that's the mount i have in my car.

Try this : 50840-SK7-010 should definitely be the right one

Hey Kyle, i think you will need a proportional valve from a non abs EF and front brake lines, here's a link to look at :...

yes that is the bolt i was on about. I removed the bracket first to get to the front bolt on the mount but removing the bracket is a bitch. There is still enough play with the sways still attached.

Hi Dan, the way i do it is remove steering column covers and undo the column from the rack(10mm bolt).. mark the spline with something so you can re-align, then undo four rear crossmember bolts and...

Hey, these are the part no's i have in my EPC:

T/Belt : 14400-pk2-004
Tensioner : 14510-pm7-004
W/Pump + Gasket : 19200-pm3-003

If you want to order a new bolt and spring for the tensioner...

You can just hammer the snapped stud out, then insert the new stud from the back of the hub then put the nut on it and screw the nut in so it pulls the stud through, but make sure that you have the...

Yeh it definitely pulls off, there's no difference between jap and aus spec, remember it has been on there for maybe 16 years, try squirting some lubricant down inside the middle of it.. that might...

Yeh man it just pulls off, try and twist it side to side as you're pulling...it can be a bitch to get off.