Search:

Type: Posts; User: ECU-MAN; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    1
    Views
    48,341

    closed doubple post ...

    closed doubple post

    http://www.ozhonda.com/forum/showthread.php?191163-Axle-lenghts-for-K20-swap&p=4015009#post4015009
  2. Replies
    1
    Views
    13,873

    Check your VTS wiring from A4 of the ECU to the...

    Check your VTS wiring from A4 of the ECU to the solenoid, ensure you have continuity, make sure the Apexi is not wired into the VTS in any way
  3. The ground point on the thermostat housing is the...

    The ground point on the thermostat housing is the ECU's main ground point and its vital for correct operation, thus making the gearbox strap equally important.
  4. What codes do you get in the ECU

    What codes do you get in the ECU
  5. I would go with " My DIY b series loom swap is...

    I would go with "
    My DIY b series loom swap is cooked and i have zigged when i should of zagged" when the ECU detects a major issue it will trigger limp mode and register a fault code. Limp mode...
  6. Thread: Brake switch

    by ECU-MAN
    Replies
    3
    Views
    12,929

    probably cruse control

    probably cruse control
  7. Replies
    1
    Views
    18,617

    I can probably fix this for you depending on what...

    I can probably fix this for you depending on what the problem is, PM me.
  8. You do not have to have a passengers side...

    You do not have to have a passengers side inflator to have this issue, if you did have a passengers side inflator you would know, follow my instructions in post 26 regarding the dummy resistor as it...
  9. Replies
    10
    Views
    20,829

    yes .

    yes .
  10. Replies
    10
    Views
    20,829

    so why would you use it as sensor ground then ?

    so why would you use it as sensor ground then ?
  11. Replies
    10
    Views
    20,829

    I would seriously rethink grn/blk being ECT...

    I would seriously rethink grn/blk being ECT ground

    ensure grn/blk goes to sensor ground on the ECU

    if you try and drain the reverse lamps through grn/wht which is what I suspect is sensor...
  12. Replies
    10
    Views
    20,829

    What engine ? what year is the car ? what...

    What engine ?
    what year is the car ?
    what engine loom ?

    regardless

    Red/wht = ECT
    Grn/Blk = Revers Light Switch Pin1
  13. Replies
    116
    Views
    210,011

    DIY James di Griz please PM me your email address as...

    James di Griz please PM me your email address as I cannot reply to your PM since you are a guest
  14. Thread: 1994 Civic EG

    by ECU-MAN
    Replies
    1
    Views
    14,321

    Sounds like the VSS

    Sounds like the VSS
  15. Replies
    6
    Views
    4,517

    You need to make sure you use the correct...

    You need to make sure you use the correct thermistor as there are different types.
  16. Replies
    9
    Views
    13,173

    unplug the ECU

    unplug the ECU
  17. Replies
    18
    Views
    25,961

    3 things can cause this delay in your situation...

    3 things can cause this delay in your situation here

    1. as mentioned the ignition switch, but I doubt it

    2. the aftermarket immobiliser

    3. the factory immobiliser.


    Unfortunately your...
  18. Replies
    116
    Views
    210,011

    DIY Hi Jason I did receive your PM, did you get...

    Hi Jason

    I did receive your PM, did you get my reply ?
  19. Replies
    2
    Views
    8,802

    No delay relay, you switch off the ignition and...

    No delay relay, you switch off the ignition and power is lost to the ECU IG source immediately, that is why the ECU is wired with a VBU to keep constant 12v for memory.
  20. Replies
    8
    Views
    20,677

    sounds like the starter solenoid

    sounds like the starter solenoid
  21. Replies
    2
    Views
    14,332

    I can fix this ECU for you, PM me for more...

    I can fix this ECU for you, PM me for more details.
  22. Sounds like the gearbox main shaft bearing

    Sounds like the gearbox main shaft bearing
  23. Replies
    116
    Views
    210,011

    DIY User DonGak please PM me your email address as I...

    User DonGak please PM me your email address as I cannot reply to your PM
  24. Replies
    25
    Views
    26,110

    Any locksmith can clone the black key If you...

    Any locksmith can clone the black key

    If you get stuck message me, I can do it a lot,lot cheaper
  25. Replies
    25
    Views
    26,110

    You can clone the last black key with out the red...

    You can clone the last black key with out the red key

    You cannot add OEM black keys at a dealer with out the red key.

    It is possible to add red and black keys if all keys are lost however a...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

» Recent Threads

Finest Сasual Dating -...
05-03-2024 08:22 PM
by Monetz
Last post by Monetz
05-03-2024 08:22 PM
0 Replies 1,584 Views
Superlative Сasual...
29-02-2024 08:18 PM
by lommyvo
Last post by lommyvo
29-02-2024 08:18 PM
0 Replies 2,034 Views
Exemplary Сasual Dating...
29-02-2024 03:50 PM
by Muzzy
Last post by Muzzy
29-02-2024 03:50 PM
0 Replies 1,601 Views

Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.