Got one on my ed/ef. With the BWR mount my swaybar is mounted the same as the eg/dc to allow fitment of the 23mm itr rear sway bar.
As a product it seems fine.
I know this is a bit late, but re the exhaust height: IPRA regs are written so that the min height is 100mm, excluding the exhaust. Meaning that the exhaust may be any height.
If you did, chances are the coilover lengths probably aren't ideal and the swaybar tension may be scewing the load unevenly.
The easiest way to get everything very...
Does anyone if the base model ED Hatch 87-91 that came to Aus had manual wind up window regulators. I'm trying to chase up a set as I want to use flat door cards on my track car and do...
If you were in nsw I'd offer you the ones off the wreck I brought. Have bonnet (has light damage and stupid stick-on bonnet vents), t-bar and passenger headlight.
The ones in the article I posted are not mine, just something I saw in browsing the net.
The jap crx and ed6 seats and rails I have, are out of the cars I have.
I have done a little more searching on this and found this diy from the US. It shows the differences in the 2 US civic seat configuarations for the civic....
The two that I have are def not interchangable. The spacing on the crx rails is much wider than my civic. I'd have to change the seat pans in from the civic to the crx seats if I wanted the crx seats...
To clarify I have an imported crx parts car, it has Aus compliance plate and firewall... so it's actual model designation and year is not clear. Lucky me...
The seats are the same as 90-91 SIR seats...
Aus ED6 headlights - 2.4kg each (glass with metal surround) these have 2 bulb plugs
Jap (civic /crx) & Aus (CRX only) headlights - 1.7kg each (plastic with metal surround) these have 1 bulb plug...
For all interested and for future reference...this is what Honda supplies on the oem 88-91 civic and crx.
1725 - 242mm fronts with drum rear
2040 - 242mm fronts with disk rear
4040 - 262mm fronts...
While I think about it...
13/16 master cylinder bore area works out about 334.3mm squared
7/8" master cylinder bore area works out about 387.6mm squared
Tell me about it, I just finished removing the abs from the loom...I think it was a jdm one which had the plates switched a long time ago. It had all the jdm climate control with japanese writing too...
The spare parts car ('88 crx) had abs, so when I tried to fit the prop valve and master cylinder a couple of hours ago...it don't fit.
The rear hole (of 2) on the master cylinder...