Search:

you MUST clear the code to get rid of the code.

REST your ECU - disconnect the NEGATIVE terminal of the battery for a short while (5 min or so) to clear codes.

i was 3/4 right dammit !

Yeah - what he said :)

*correct me if wrong*

the ECU is in the same place ( passenger kick panel) or under the passenger seat. The ECU light is located on the ECU , in the centre and will flash a code if needed.

the connector you are after is a 2 WIRE connector.
Keep looking its there.

try and look around the same area - should be there somewhere.
Here is the location according to the official HONDA EK guide -

http://www.ozhonda.com/gallery/data/500/ECUTEST.jpg

ive done 2 ECU tests on EKs - a EK1 and a EK4.

The Wire is located in the same place. Try and look up inside the back of the glove box etc.

the VSS ? Its a black plastic plug located ontop of the differential housing.
Right near the rear engine mount - It has wires coming out of it.

Or do u mean the ECU test thingy ?

VSS = vehicle speed sensor. Its located ontop of the gearbox diff housing ~ pretty much right above where the 2 driveshafts meet in the middle. Check that its plugged in correctly...

its the plug with 2 wires on it. Use this guide the same way....

Yes , but please check with the location of the ECU connection - it maybe slightly different or a different location to my EG civic.

with ur current ECU....wait for ECU MAN to reply or get onto HT or similar , and see what those apply for accord ECU :)

to add....most of these "diagnostic codes" are not known until you actually log onto the ECU via this DIY way or on a actual diagnostic tool.
More so the point of this - is to diagnose problem areas...

Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own...