Search:

I couldn't pass 4k rpm and had a engine light because my battery didnt have enough charge.
Just a thought.

Thanks for the advice guys, found out i had a ground wiring cut. Quite annoying.
But still it's fixed!

So Tom all these issues will be resolved if I just replace the Iacv?
I'm getting one tomorrow so that's a good thing lol

Hey guys just got my k swap going, problems I'm facing so far are:

-k pro saying that the Iacv has a error
I have taken it off 4+ times and have cleaned it with degreaser and also my dremel so it...

What was peoples thoughts on the malaysian race last week?

It's all good guys, just gave it to a power steering place, guy quoted me $40 so i can't complain lol

thanks anyways.

bump....

Hey guys, I have bought hardrace power steering bushings and I have wasted hours trying to put them on.
Myself and Mocchi couldn't figure it out.
Can anyone tell me how it's done?

Thanks guys.

I think I'll pass on altering my bumper, gonna cut and weld he rad tabs.

Thanks for the pictures though.

I would like a picture if it isn't quite a hassle. Just can picture it by imagination.

Lol what's a spoon rad support? Never seen one. Light weight?

I got a eg but doing ek front again and yes it's a genuine rad support. So I can mod my rad support for the front bumper? So just weld the tabs to make it fit?

Really? Thought they where all the same besides hatch or sedab, due to people putting facelift parts on Pre ek's

Hey guys I just purchased another ek rad support, and my front bumper doesn't line up to the 2 middle holes.
I asked for a hatch one and the wreckers said all ek sedan and hatch rad supports are the...

Looks so clean, just by looking at it you can tell the owner takes care of it like it should.

Guessing by your DP it's a EM1 you have?
JDMyard has both aftermarket and oem endlinks.
Have a look at his trader section, might be cheaper than what Honda will quote.

Gave it a go. Not enough space with a breaker bar.
And tried with a ratchet not enough space to put all strength into it.

Hey guys currently tryin to remove rear engine mount, it's a real tight squeeze.
I've got the car on 4 jack stands and it is the last thing I need until I can continue with removal of engine.
Any...

Because you loved the ek so much why don't you go down that route again? you can always get a gli and swap an engine in it also, and then you would have a much more of a powerful engine than the ek4....

Well due to me liking power i would go a cheap eg and swap an engine (b18c2) in it and still should have some spare coin for some handling mods.
But thats my preference. All depends on what your...

Bro that's wings west, thats my old one that i gave to mango lol i can tell by the hit on your left hand side of the lip.

Hopefully this persistence pays off. I'll be keeping an eye for your posts.
Good luck

I've been suggested to take all them out then take to a engineering shop and
Get them to replace them.

Just some bolts are threaded/ rounding and would just like to replace all.
Just want everything new that's all.

Wasnt sure where to place this.

Hey guys I am aiming to replace all bolts/ nuts on my whole rear end (suspension/subframe/lca/camber arms/ etc)
I am wondering if anyone has the details for each...