Search:

You cleaned your fuel filter?

Pull injectors off are see if theres crap built around the nozzles. Bad spray pattern could be the cause.

When I did mine they were a bitch too, ended up using 2 G clamps. 1 each side of rta, crank them as tight as you possibly can then knock it with a brass hammer and it goes in like 1cm at a time....

Looks a fair bit off.

When I went to get nighthawk paint, they showed me like 4 different variations off that 1 single paint code.
Supposedly Honda used different variations depending on year and...

Problem with parking in sun, them blotchy patches look like paint oxidation or almost there.

If you can afford or do yourself, sand back and respray base/clear maybe primer at the areas that are...

Is it okay to transport an engine on its side? I don't see why I couldn't.
(will be drained of all fluids of course).

Only doing so because it won't fit in the car I have standing up.

That doesn't look too bad, I reckon a cut and polish or a really fine wet sand then cut/polish should do it.

Fuel surge? as in fuel cutting out?

If your car is old then it's probably your fuel pump strainer/filter. My 94 dc2 had similar problem, when 1/4 tank left sharp or fast turns/corners would cause...

Kinda common sense to put space saver on the rear, as the front wheels both steer and transmit power so you'd want them even.

Sounds like yous are right, front left was +3mm and right was +0.2.
All good now, but I still have to get some new tyres.

Cheers fellas.

Hi, I'm getting ridiculous camber wear on the inside of tyres.
I'm running after market wheels, stock suspension and height and have recently replaced all suspension bushes (wheel is very firm when...

It probably is, Mine does same thing whenever I open a door hazards come on, found out it was the alarm/central locking system, I just located the control box and disconnected the wires that control...

Any other suggestions?

Hi, front shocks in my 93' dc2 are just about gone (leaks and heaps of body roll now).

I want to get coil overs and lower 30mm or so with a budget of $900 or so.

Was thinking Koni yellows...

T10 wedges, you can get pretty bright ones of ebay for cheap
...

Today I took the car in and got Ivan at high power racing to take a look.
Fortunately everything is running good (better than the last engine) however he did point out that my check engine light...

Oh and last engine, blown headgasket (alot of steam was coming out and oil was loaded with water). Had the head machined and tested, then got new gasket and put it together myself and still had steam...

Get OEM if you have money.

I've used aftermarket polyurethane ones off ebay before. They have no clamps so they slip off whenever you take the ball joint out.

However they are really thick and...

The grounding problem was spot on, fixed. Thanks.

Recently my 93 vtir teg engine died. I source a new one from hi power racing and put it in myself. It has approx 30xxx km's less than my old one.

I put it in myself, I got a new clutch while...

Could possibly be coolant burning to make piston that colour.

Or could be really rich mixture?

White smoke even after a head gasket change (head was machined 0.2mm)

No water in oil, so maybe the coolant pockets around pistons are leaking into combustion chamber? (block needs machining...

Yea good point. Best you get a slim fan if you still want that aircon to perform 100%

^ Usually head bolts have a yield point and torquing them down will pass this point. Once passed they will be out.

Best bet get a new set.

I was able to keep one fan (the left one facing the engine, the bigger one)
You'll need slight modification of the fan bracket to fit it nicely (I just pulled the dremmel out and cut away abit of...

Yes it will, a while back I bought that exact same radiator, however my stock hoses were old and broke when I took the old radiator out so I got a new set from ebay too.

Just make sure that you...