Search:

Type: Posts; User: hondapop; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds; generated 21 minute(s) ago.

  1. Replies
    4
    Views
    29,483

    Manual shifting of DC4 auto transmission

    I recently discovered that it seems to be possible to manually select and hold/limit the 4 stages of the automatic fitted to the DC4 Integra. Also it's possible to shift down through the stages using...
  2. Replies
    180
    Views
    13,681

    'Nuff of the yo yo'ing already, making me feel...

    'Nuff of the yo yo'ing already, making me feel queasy watching the page bounce up and down. So, a B18a1 eh. Investigate the possibility of B18B2 pistons to see if they have a higher crown. The...
  3. The answer to the OP's question is obvious. If he...

    The answer to the OP's question is obvious. If he ADDS an exhaust, then yes it will slow him down (will need a trailer axle too!)
  4. Yes, bigger main jets. Not sure what type of...

    Yes, bigger main jets. Not sure what type of carbies were fitted to yours, but if they are the type with a tapered needle that lifts out of the jet to allow fuel to enter the airstream, then both...
  5. Replies
    180
    Views
    13,681

    Strange that the doors would be different between...

    Strange that the doors would be different between Accord 2 doors, especially at the front A pillar. May mean the windscreen is different too. I could understand the B pillar end being different...
  6. Here's some info to either cure insomnia or cause...

    Here's some info to either cure insomnia or cause it, http://www.ring-plug-thread-gages.com/ti-Article-JIS.pdf
  7. That is interesting, haven't heard of that one, I...

    That is interesting, haven't heard of that one, I guess JIS stands for Japanese Industry Standard? Wonder if the threads are a different pitch to others as well.
  8. Usually caused be using a too small screwdriver...

    Usually caused be using a too small screwdriver tip. Phillips head screws require a close fitting tip of the correct size. The age of these would also mean, the threads have probably seized.
  9. The last carby'd car I had was the GA2 City and...

    The last carby'd car I had was the GA2 City and that was only a single. It had enough hoses to deter me from touching them. As I remember several went into a "box". Never found out what was in there,...
  10. The only thing I can suggest is get a small vise...

    The only thing I can suggest is get a small vise grip, clamp each hose off 1 at a time and see what effect that has.
  11. Replies
    2
    Views
    2,517

    Are the threads stripped out i.e. the bolts screw...

    Are the threads stripped out i.e. the bolts screw in but slip when tightened, or are they cross threaded at the start? If they won't tighten but are fully screwed in then to re-tap new threads in,...
  12. Replies
    16
    Views
    7,127

    OP's a bit slack in following his own thread....

    OP's a bit slack in following his own thread. :confused:
  13. Replies
    16
    Views
    7,127

    Honda's wiring diagrams, like the one the OP has...

    Honda's wiring diagrams, like the one the OP has posted, they tend to only show circuits as they apply to a particular item, don't give a very good overview of how those circuits interact with the...
  14. Replies
    16
    Views
    7,127

    On my first Honda (CA Accord hatch) I once had...

    On my first Honda (CA Accord hatch) I once had the brake warning light staying on and couldn't find the reason. It turned out to be a blown brake light bulb. On the back of the tail/brake/reversing...
  15. For street use and fuel economy, a bit of warmth...

    For street use and fuel economy, a bit of warmth in the intake air is a good thing, otherwise you're just chucking unburnt fuel out the exhaust. For racing you're after the maximum amount of air...
  16. Replies
    16
    Views
    7,127

    Check your brake pedal where it contacts the...

    Check your brake pedal where it contacts the brake light switch. Not sure if Honda ever went away from this set-up, but on earlier models there is/was a soft plastic stop button that presses into a...
  17. Just to add to that, I had a Valiant Charger back...

    Just to add to that, I had a Valiant Charger back in the 90's that had a Cain alloy intake manifold that was not attached to the exhaust manifold (hotspots they were called, which prevented the...
  18. The carby models had a mass of tubes going all...

    The carby models had a mass of tubes going all over the place, early PGM-FI's weren't much better. That particular vacuum valve is as Sp33 says, draws warmed air off the exhaust headers to help...
  19. What I forgot to mention clutch wise is the need...

    What I forgot to mention clutch wise is the need to get the appropriate flywheel to match the different size clutches, definitely in the case of the 190mm but not sure if the 212mm will fit the 200mm.
  20. Where you at Michael? Suspension upgrades and...

    Where you at Michael?

    Suspension upgrades and semi-race tyres on 15 x 6.5 rims for a start. If you don't want to go whole hog with adjustable coilovers, Skunk2 make shortened sports shocks,...
  21. Replies
    180
    Views
    13,681

    Not my cup o' tea. Give me dials with needles...

    Not my cup o' tea. Give me dials with needles everytime, have hated digital dash displays ever since the one in the XF Falcon I had. Nothing like the swing around the dial of the Tacho needle. If...
  22. Bought a set of Skunk2 shortened sports shocks...

    Bought a set of Skunk2 shortened sports shocks for the Gen2 CRX.
  23. Replies
    180
    Views
    13,681

    In that article I was referring to it said the...

    In that article I was referring to it said the fixed lights were standard in Japan and only some special editions such as the Accord Vigor and your Aerodeck got the pop-ups (nick-named "bedroom...
  24. Replies
    180
    Views
    13,681

    The car it came out of was most likely a Euro...

    The car it came out of was most likely a Euro sedan luxury model because it didn't have the "Vigor" name across the back in a garnish between the tail lights (saw one of those in a wrecker). They...
  25. Replies
    180
    Views
    13,681

    The problem with these motors/boxes, is that they...

    The problem with these motors/boxes, is that they sit at a different angle to any of the others, (more forward lean than say a Teg B18a1),except maybe the A20a's that were the norm here. Don't know...
Results 1 to 25 of 492
Page 1 of 20 1 2 3 4

» Recent Threads

Finest Сasual Dating -...
05-03-2024 08:22 PM
by Monetz
Last post by Monetz
05-03-2024 08:22 PM
0 Replies 2,809 Views
Superlative Сasual...
29-02-2024 08:18 PM
by lommyvo
Last post by lommyvo
29-02-2024 08:18 PM
0 Replies 2,672 Views
Exemplary Сasual Dating...
29-02-2024 03:50 PM
by Muzzy
Last post by Muzzy
29-02-2024 03:50 PM
0 Replies 2,220 Views

Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.