Search:

dc5/ep3 coilovers will fit eu3. will need front tie rod ends from dc5/ep3 to fit the front, and the rear coilover need to be grounded down just a little bit at the bottom to fit. other than that, no...

your eu3 shares alot of parts with the es1, ep3 and dc5. any of those springs should fit. lowered springs on standard shocks will give you a bouncy ride :)

congrats on the eu3!

only part of the ep3 kit that will fit is the front bumper. the side skirts, rear bumper and wing don't fit without modification. there was someone on here who had someone...

^^ same place i went to, good quality and good price! the pre-fabbed exhausts from the us are a bit pricey for what gains it gives, which is close to nothing really.

The headlight bulb is H4.

Hello,

Pretty much all mentioned above.

If you have prefacelift, the front end of a EP3 should be direct swap. Headlights, i'm not sure of as EP3's came with standard HIDs and EU3's came with...

you can use either h or b series gearbox for the swap.

hmm.. im just saying, im not sure if they are going to fit since they share the same suspension parts with the ES and EU we have here. if anything you should've probably got the ep3 si tie rod ends...

em2 is the 7th gen coupe. we don't get them here, i think it's only in us and europe.

nGGGG!

hey guys, didn't want to start a new thread for this topic but what happens if the car is bought interstate and was registered over there with a H22 into EK. do i need to get VASS here in melb before...

the es1 and eu3 tie rod ends are smaller than ep3. the bolt that the cotter pin goes through that is.

my bad, sorry!

im pretty sure dc5 and ep3 share the same tie rod ends. good luck with the car!

Awesome! Thanks guys!

Hello all,

I was wondering if there are any off-the-shelf exhausts that will fit? or will it definately have to be custom made for this? Thanks in advance!

Cheers!

should stick to factory wheel diameter which is 185/70/14, so a 205/50/16 tyre should keep your speedo accurate.

i used the 02 - 05 civic si cluster from america. the redline is the same, only thing different is that it runs in both mph/kmh and the odometer reads in miles. direct replacement.

nope, not smoked. difference between prefacelift eu and ep is that ep comes standard with hids, and eu has halogens so there will probably need some modifications to change them over.

not at all, i used a battery operated drill. good luck with it!

i used those screws that drill their own holes as you screw them in.

new spacers, they came with the clarion speakers i bought a while back.

will fit if you use spacers but you might not be able to fit the door trim back on over it. i put 6" in the back with spacers and they just fit over, small gap at bottom but not noticeable. 6" at the...

i'm pretty sure the tie rod ends are only to correct toe. to adjust for camber, you either need to have camber plate tops on the coilovers or a camber kit for the dc5 mate. good luck!

you can only swap an engine that is the same age or newer than the chassis's age. most of the time, its the k series that gets swapped into our 7th gens. they have been doing it for years in the...