Search:

Thanks for the info mate. Pretty sure the hid level is attached to the shocks/coilovers so shouldn't mess with the arms.

I will look into that. Thinking i might just raise it for now to see if i...

Silly question, but have you checked fuses?
Honda seems to have separate fuses for a lot of things (i.e. fuse for each headlight, parker, fog etc).

Hi all,

Got my cl9 fairly low and last wheel alignment shows camber is out between -2 and -3 (and toe is out too but cant remember how much).

I was wondering if anyone knows the minimum...

I have the same deal. Very noisy when in 3rd gear and dropping revs.
I am leaning towards a clutch related problem and as stated earlier, could be thrust bearing (which is no big deal as brand new...

stop parking on a hill with the front pointing down?

Oil in the sump will be anywhere but below the pickup.

it is? I thought the brake bias was toward the front, so the fronts would wear down quicker.

Either way, sounds like the front brake pads have been replaced numerous times, where you will find the...

Alternator or battery.

Head down to a battery place and they will give you a free check on the battery and let you know what is up with that.

did you buy cheap LEDs?
try original lights in there again.

It could be that the leds that you got are faulty or that the connection with the terminals is bad.

it may look a bit off, but what about using a bit of thin fishing line to mount it? use the 3M backing sticky tape as well but strengthen the bond with fishing line.

yep definately an aftermarket alarm system that is playing up. Explains the battery drain and blinkers.
Do you have any sort of manual over-ride key on your key chain? if so, using that might stop...

also interested. Not needed asap but be nice to have :)

The driveshafts were brand new.

No.
It only happens when accelerating and is worse with load (especially when in second gear below 40km/h and then accelerating).

Hi all,

I know there are a couple of threads out there about the CL9 shaking but I thought I would share my problem in a new thread.

- I have replaced the entire front driveshafts with new...

At that speed it could be wheels out of alignment or lost a weight. I would get that looked at first before you go into the CV joint direction.

Yep take the front bumper off. Might be able to get away with just taking the underbody plastics off but not sure.
Mount the ballasts away from anywhere that can have standing water. Double side...

Argh my bad. My nissan has hydraulic lifters so I was kind of going off that.

- Occassionally use a lifter-free additive to ensure the lifters are cleaned and working at full potential.
- change your gearbox oil more regularly than in the service manual. I do mine every...

- Regular oil and oil filter changes
- Regular spark plug changes
- Use good quality fuel
- I use injector cleaner every now and then
- Carbon build up can be removed with throttle body cleaner....

take the cap off the clutch MS reservoir and check where the oil is. It looks to me to be over max level but as you say hard to tell. Easiest way is to look inside.

If it's only second gear, most...

how low is your car?

I've had 8+30 on mine with stock suspension and it fit fine. 8+35 will have 11mm less inner clearance but will have 1mm more inner clearance than the stock 17x7+55. So it...

Check this out --> http://www.fixya.com/cars/t5780847-honda_accord_euro_2005_vsa

Particularly, the advice from magdielp because it is related to the transmission:



So I would first check...

umm take it back to the mechanic who installed it....

195/45/17 is too small for the 17x7+55 wheels.

Your rolling diameter is -4.3% of what it needs to be (http://www.1010tires.com/Tools/Tire-Size-Calculator/225-45R17/195-45R17).

About 4.5L (that is with the oil filter change). Less oil if you don't change the filter (about 4L i think).