Search:
Type: Posts; User: Fo55il ; Keyword(s):
Search :
Search took 0.02 seconds.
hey guys,
for an EG, what would be required for a swap from b18b2 to B18CR. b18b2 is running in the car atm.
yeah, it was. sold now i think
im looking to get a car from qld that has had a engine conversion.
more specifically looking at getting this
*************Sexy beast*************
its had a conversion.
to register it in...
dont use leds. they dont spread the light as much. hence y u got that. i got the same thing.
check if ur o2 sensor is plugged in properly. check the plugs n clips.
yellow s2k watch fnf1 again
bowser was sellin one a while ago.
ive seen 2-3 round melbourne.
yellows2k how can i bypass this resistor bra
mine rnt bright at all
emanage. fmic injectors. fuel pump.
greddy bolt on.
100 wid 7 psi
lukez stock held 12.
im on 7-8
Do it.
low boost and regular upkeep should do u fine.
i blew a motor cause my rad was leaking.
ull see a considerable gain.
contact lukezen if u need some help
if anyoen can get a better price hit me up
upgrading handling and was wondering if this was a good deal.
2pnt front strut brace
4pnt rear strut brace
front lower brace
floor bar
for $542.65 delivered
all ultra racing bits.
wtf is a eg6 sedan twin carb ?
thats bs bro,
i been in it
n its not loud at all.
farkkkkk offffffff
as if honda drivers dont hooooonnnnnn
i had a similar problem. check ur earth's.
my headlights werent earthed properly and the headlights were very dim.
farkin how to make my eg6 cluster brighter
thats wat i wanna kno
definately vouch for RAY at ART
changing the rear hub bearings.
got the axle nut off and the lil clip off too.
cant seem to get the bearing assembly to come off.
am i missing sumthin hea.
i tried yankin it and...
i farked my rear hub up a bit, studs wotn stay in
question is
can i use the bearing from a 'drum' breke setup on my disc brake setup?
just need the rotor bearing that the studs sit in ...
well, i was extending the studs cause i got sum.
3 fit ok 1 seems to not stay in tehre and keep rotating.
i put in the old one to test and it farkin fell back in the hub and annoyed the ****...
im askin if i need to change the whole assembly or can i just change teh hub bearing?