Search:

PM sent, thanks.

Hi ECU-MAN, tried to pm you re: an ek1 1998 model immobiliser issue. But your pm was full. Thanks.

Yes there are notches on the shaft. I think they are there to stop the boot from slipping too far down the shaft. See attached image, you can just make out the notches in my shifter cable install...

It should just slide off.

If you aren't able to get it off, you can always unscrew the boot and large silver plastic ring off from the trim. There are 3 screws holding it in, you can see them in...

I was sick of getting defected in the 180, plus it was getting a bit dated.

Thanks viett!

Here you go:

http://nissansilvia.com/forums/index.php?showtopic=417218&st=0

Wasn't too sure if it still existed :p

Anytime Azz86. A long time reader :thumbsup: nice!

I'd also try dialling some more front camber, if you are able to for your next outting. If your camber tops are aready maxed out, you could look...

Azz86, my 2 most recent track settings were:

Front camber: -3.0
Front toe: -1mm total toe out

Rear camber: -1.5
Rear toe: 3.0mm total toe in

Similar/same suspension setup to yours. BR BC...

The only other mods I have up front are roll centre adjuster, aftermarket lca bushes and camber bolts. Which were added to refine my setup and help with the alignment.

Can't really suggest...

Try upgrading your tie rod ends, that should help.

My EP does that too, but it's not really bad. Only time it was really bad was the first time I took it for a spin after installing my engine...

Shouldn't be any issues. A few mates of mine run 17x8.5 +31's all round with 225/45's and I think the other runs 215/45's. Only very slight rubbing under load in the rear on the 225/45 setup, on non...

JC I can confirm the part number listed by UNA91 is for the primary sensor. Same part number as listed on the box I got from JDMYard.
...

How could you hate it? Its great! Jump back into a normal car and it just feels weird :p

You could try getting one of these?
...

A mate of mine gets around on a set of Advan RGII's which are similar offsets, 17x8.5 +31 with 225/45's all round. Scrubs a bit under hard cornering in the rear and when the back seats are loaded up....

Found another wheel/tyre fitment calculator, this one also allows you to enter your camber settings and it gives you a diagram of it too!

http://www.fitmywheels.com/

AWESOME!!!

Tyre sizes sound fine.

Depending on which wheels you run at the rear, you may/may not have enough inner clearence to the rear trailing arm. (I'm not 100% at stock height)

Fully lowered, I've...

I was looking into the same part a while ago, I ended up getting an aftermarket actuator installed instead. Coz I was having a hard time sourcing the correct OEM replacement for cheap. Worked out...

Good work on collating all that info lolmclol :thumbsup:


Found a handy "Wheel Fitment, Tyre Stretch, Rolling Radius and Speedometer Error" calculator, which allows you to kind of visualise how...

Engine Oil: Castrol Edge 5W30 for track and sometimes daily (currently using it for daily use) it burns around 100-200ml every 2-3 weeks depending on how hard I push it. I've also use Calibre 5w30,...

Thanks for the info butterfingers.

I'll look into them.

Anyone here looked into buying a mugen or seibon rear wing recently? I'm having a hard time finding one at a decent price.

They're also now discontinued from mugen :(

Cheapest seibon one I can...

Anyone know where to buy extended wheel studs for the ep3?

Cheers for the info UNA91.

Any of you guys running aircon delete kits on your ep's?

I'm considering deleting my ac, rather than regassing it.

Wondering if it gains any power without the ac, or is it just to save weight?