Search:

Type: Posts; User: aaronng; Keyword(s):

Page 1 of 19 1 2 3 4

Search: Search took 0.23 seconds; generated 44 minute(s) ago.

  1. Replies
    3
    Views
    7,533

    You will have to bed in your new brake pads. Also...

    You will have to bed in your new brake pads. Also depends on your brake pad type. Usually when you change to new pads and don't adjust the parking brake cable, the rear brakes will be engaged all the...
  2. Just make sure they use the correct rear...

    Just make sure they use the correct rear winscreen as your radio antenna is integrated into the top part of the glass.
  3. Replies
    9
    Views
    5,787

    Those voltages look okay. If idle fluctuates when...

    Those voltages look okay. If idle fluctuates when you use the door locks, then it should also fluctuate when you turn the lights on and off. Try that out. However, from your battery and alternator...
  4. Replies
    16
    Views
    14,871

    You can use a flash light to look at the...

    You can use a flash light to look at the compressor clutch. The outer ring will be spinning and the centre will be idle when A/C is off. When A/C is on, the clutch engages and the middle will spin as...
  5. Replies
    9
    Views
    5,787

    I have 6 AWG grounding wires, but didn't notice a...

    I have 6 AWG grounding wires, but didn't notice a difference in starting performance. I believe the quality of your battery plays a much bigger role. I'm using Supercharge Gold batteries now...
  6. Replies
    9
    Views
    5,787

    Quite normal. Even back when the CL9 first came...

    Quite normal. Even back when the CL9 first came out (mine is a 2004), we would experience some struggling to start when the engine was warm. We suspected that there was some residual fuel in the...
  7. If it is the inner CV joints, it vibrates at...

    If it is the inner CV joints, it vibrates at about 55 km/h and 110 km/h under acceleration. Is that happening to yours? I went the aftermarket route for $280. Worked well. Then I noticed the engine...
  8. If the rotors were glazed, just run some 80 grit...

    If the rotors were glazed, just run some 80 grit sandpaper over it. That's why I do each time I replace a set of pads.
  9. Replies
    12
    Views
    8,911

    Try holding in a higher gear as you slow down...

    Try holding in a higher gear as you slow down approaching an intersection. If the beep never occurs then, then your belt may be too long. Stock belt is a 7PK1750. On mine, when I changed the air con...
  10. When you bleed, make sure the slave cylinder...

    When you bleed, make sure the slave cylinder bleed valve is opened sufficiently. There is only enough space to turn the spanner 1/4 turn, and that is not enough to open up the bleed valve. You'll...
  11. Replies
    9
    Views
    2,798

    It should still cut off at redline. Having a...

    It should still cut off at redline. Having a manual gear box from the 2000's means that it does not have a sensor to tell which gear you are in, unlike the newer 86/BRZ.
  12. Replies
    22
    Views
    34,359

    Mine is not a CU2, but CL9. Even after the...

    Mine is not a CU2, but CL9. Even after the following mods: Cold air feed short ram intake, intake manifold gasket, aftermarket headers, lightweight flywheel, helical LSD, Tein Flex coilovers, rear...
  13. Replies
    9
    Views
    2,798

    Interesting, never tried hitting cruise control...

    Interesting, never tried hitting cruise control in neutral. Now we know.

    Was it in gear, but clutched in?
    Or was the gear stick really in neutral position, and clutch pedal released?
  14. Replies
    4
    Views
    2,275

    It's OBDII compatible, protocol is ISO. I have a...

    It's OBDII compatible, protocol is ISO. I have a bluetooth OBDII reader that I use with the Torque app for Android. Works fine.
  15. Replies
    5
    Views
    3,403

    Does the sound go away when you turn the A/C off?...

    Does the sound go away when you turn the A/C off? Mine has that whining sound as well after I replaced the A/C compressor. It is there very clearly when accelerating with A/C on. It goes away when I...
  16. Hi William, This is a common problem, which...

    Hi William,
    This is a common problem, which relates to the accelerator pedal position sensor. The fix is to replace the sensor and your car will work fine again. There are a few threads on this in...
  17. Replies
    6
    Views
    4,370

    Inner CV joint. Had the same issue on my Accord...

    Inner CV joint. Had the same issue on my Accord Euro. Vibration was at 55 km/h only, and only under throttle. It would also vibrate at twice that speed, 110 km/h, which was obvious on the freeway.
  18. They all work the same, since the Euro's A/C...

    They all work the same, since the Euro's A/C system is not rated to run high efficiency filters such as HEPA.

    The ones in the link will filter out your usual dust, pollen, bees etc, and the...
  19. Replies
    6
    Views
    588

    Labour is a pain. If you choose to DIY, note that...

    Labour is a pain. If you choose to DIY, note that you will need to disconnect the top radiator hose (some coolant leakage if you don't drain part of it out first) and remove the radiator fans to...
  20. Yes, if you do a search for "alignment" in the...

    Yes, if you do a search for "alignment" in the Accord section, you will find it. http://www.ozhonda.com/forum/showthread.php?p=3211385#post3211385


    No obvious signs, other than vibrations. Even...
  21. Replies
    6
    Views
    588

    The Accord (V6 and Euro) have a front hydraulic...

    The Accord (V6 and Euro) have a front hydraulic mount, which is connected to a vacuum line. When that mount wears out, you get 2 effects. Firstly, the vibration dampening which actually matches with...
  22. Replies
    12
    Views
    33,431

    Toothpaste will take a LONGLONGLONGLONG while....

    Toothpaste will take a LONGLONGLONGLONG while. You can try it on a small section, can't get any more foggy anyway!
  23. I'm a fan of Honda ATF, because of the odd...

    I'm a fan of Honda ATF, because of the odd viscosity. However, Penrite should be okay, just check that it lists Honda as one of the OEM standards that it meets.


    Good idea, it is a standard auto...
  24. Replies
    6
    Views
    588

    Welcome! The issues you described are typical of...

    Welcome! The issues you described are typical of an older car. My 2004 Acord Euro has similar issues. For your shuddery automatic, first thing is to replace the transmission fluid with Honda ATF. The...
  25. Replies
    12
    Views
    33,431

    Check if the fogginess is on the inside or...

    Check if the fogginess is on the inside or outside. If outside, it is an easy fix.

    Repco used to sell a kit to restore headlights. However, the only thing special was the acrylic spray, which...
Results 1 to 25 of 468
Page 1 of 19 1 2 3 4

» Recent Threads

Finest Сasual Dating -...
05-03-2024 08:22 PM
by Monetz
Last post by Monetz
05-03-2024 08:22 PM
0 Replies 2,809 Views
Superlative Сasual...
29-02-2024 08:18 PM
by lommyvo
Last post by lommyvo
29-02-2024 08:18 PM
0 Replies 2,672 Views
Exemplary Сasual Dating...
29-02-2024 03:50 PM
by Muzzy
Last post by Muzzy
29-02-2024 03:50 PM
0 Replies 2,220 Views

Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.