Results 1 to 3 of 3

Hybrid View

  1. #1
    Newcomer Array
    Join Date
    Jan 2007
    Location
    Sydney
    Car:
    93 EG Civic

    Wiring up Vtec D16y8 to p28 ecu

    Hey everyone im having a few problems wiring vtec in my eg civic i know there are 2 wires that i have to run from the ecu A4 D6

    From my understanding A4 connects to the the vtec spool solenoid but where does D6 connect to ?

    I have seen on rywire that i have to connect D6 to the vtec pressure switch but the D16y8 doesnt have on there is just a bolt where it would be also with the vtec pressure switch it has two wires comming out of it
    so if anyone and enlighten me with this problem as its holding me back on getting this car finished

    Any help would be greatly appreciated

    Thanks

  2. #2
    connect the VTEC solenoid wire to A4 (VTS).

    Connect the VTPS wire to D6 and VTPS ground to the VTS itself.
    Last edited by bennjamin; 03-04-2009 at 06:04 PM.

  3. #3
    Newcomer Array
    Join Date
    Jan 2007
    Location
    Sydney
    Car:
    93 EG Civic
    ah so now i have to source a vtec pressure switch hmm
    i have heard that you can just use a jumper from d6 to a4 then connect a4 to the vtec spool solenoid has anyone done this ?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.