Comprehensive Ek Civic Led Cluster and Climate control Conversion *Updated 22/07/11*

[TbM]

I havent tried myself but i dont see why you wouldnt be able to do it without removing the climate control. You would have to remove the lower panel thats in my hand to see the bottem of the climate control.

Then if you can see where the bulbs are located in this pic of the bottem of the climate control then you just have to try get your hands or some pliers in there while its still in the dash to get the bulb holder out.

[JDM EM1]

Okay. Thanks heaps

[TbM]

No worries mate i hope it helps

[JDM EM1]

Just changed all my bulbs and noticed the demister and hazard backlights dont work?

But the the hazard and demister work.

Know what i wouldve done wrong?

[JDM EM1]

Nevermind, figured it out, it was the bulbs. Do you know where i can buy the demister backlight globe and hazard globe?
Or have any idea what they are? T2's?

Thanks in advance

[TbM]

if you want you can just reuse your bulb holder and put a 3mm led with a resistor in there like in the pic below.

Ill check what bulbs they are tomorrow for you, i didnt take note of what they were so ill have to pull one out and check it.

[JDM EM1]

I want to make all of them the same brightness. Yeah okay let me know. Thanks heaps. This thread was really useful!

[TbM]

I want to make all of them the same brightness. Yeah okay let me know. Thanks heaps. This thread was really useful!

You can make them all the same brightness by using a 3mm led you just need to use a lower resistance resistor if you want it brighter or if its too bright then sand the led to diffuse the light or use a higher rated resistor.

I didnt have much time this morning so i only quickly checked the bulb out for you but i dont know if ive found the proper name for it sorry, ill have another look later after i get back but it seems to be called a Neo wedge type A(T3) from what i can tell, If you take yours down with you to repco, supercheap, autobahn etc im sure they can help you.

Heres a diagram of the measurments,



heres some example links.

About a third of they way down the page there is neowedge bulbs
http://autolumination.com/74.htm

Heres a link from the site i buy my leds from
http://www.superbrightleds.com/cgi-b...pecs%2FNEO.htm

[JDM EM1]

Thanks heaps mate

[TbM]

No worries mate hope it helps, If you want to try using 3mm leds instead of the stock replacement bulbs im happy to help you work out which leds and resistors to get, You can also get away without soldering the connection if you dont have a soldering iron but its always better to use one if you have one.

[wtfalfred]

HEY TBM,
which LED did you use on Cluster?
On my cluster, I only can see LED colour without bright

[TbM]

HEY TBM,
which LED did you use on Cluster?
On my cluster, I only can see LED colour without bright

Sorry i dont understand what your asking mate, the type of leds i used are listed on the first post of the first page.