i think the jazz has a speednut/washer thingy on it, like the pins go into the car and then on the otherside they pop a then washer over the pin and that holds it onto the car nice and tight.
if u go to pull it of, the pins snap or the washers do.
but u can still use silicone to hold it in after. i took mine off used a cheap red one (which faded yellow and the red melted and sank to the bottom of the badge), so i grabbed some CF wrap and cut it to shape put the holes in it and made a BOSS cf background badge
I'm not kidding, the glue was half melted so i just pulled it, watched it stretch slowly and it came off
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
haha dat local knowledge
how did you put the Honda Badge on then? stick the pins in the hole and glued it on?