ITR JDM Hub on EK GLI

[mocchi]

ah fuk. well just get another passenger shaft then, sell the 36mm

[MEN15S]

ah fuk. well just get another passenger shaft then, sell the 36mm

Easier said that done.... been looking do you know anywhere ?

[mocchi]

man this is so confusing lol.
36mm hub with d series?
you need 36mm outers, call driveshaft shop to make one if no one selling

[MEN15S]

man this is so confusing lol.
36mm hub with d series?
you need 36mm outers, call driveshaft shop to make one if no one selling

Yes 36mm with d16

Got one made it ended up been a bit too long and couldn't bolt up the hub

[neut]

Theres alot of talk about JDM ITR 5 Lug on D series Engine on American honda sites, if you google it. No one seems to know what works....

[MEN15S]

Theres alot of talk about JDM ITR 5 Lug on D series Engine on American honda sites, if you google it. No one seems to know what works....

I've been Google my ass off lol no luck I think this is why the guy sold me the 5 stud for cheap he knew one side was jdm

[dorikin]

Just fix the actual problem and replace the hub

Don't try work around it replacing cv outers driveshafts etc

[MEN15S]

Just fix the actual problem and replace the hub

Don't try work around it replacing cv outers driveshafts etc

Try that as well unless you know someone that will sell me just one hub everywhere I call say will only sell all 4 hubs as a complete setup will not part out with one hub for a itr

[dorikin]

try harder

if you're calling up wreckers or private sales then you're looking in the wrong place, no one is goin to separate 1 hub from a complete set obviously

look at getting a brand new hub from honda dealer, even aftermarket hubs are available...

[MEN15S]

try harder

if you're calling up wreckers or private sales then you're looking in the wrong place, no one is goin to separate 1 hub from a complete set obviously

look at getting a brand new hub from honda dealer, even aftermarket hubs are available...

From Honda hub alone is $332

[mocchi]

Yes 36mm with d16

Got one made it ended up been a bit too long and couldn't bolt up the hub

you use d series drive shaft with 36mm outer?

[MEN15S]

you use d series drive shaft with 36mm outer?

Su woop made them up for me