Page 1 of 2 12 LastLast
Results 1 to 12 of 18
  1. #1
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2

    needed b18c7 wiring diagram

    about to swap out my b18c2 for a b18c7 and need a wiring diagram as the loom I got with the engine had a plug cut off thanks

  2. #2

    needed b18c7 wiring diagram

    What colour are the wires
    And where abouts on the loom

  3. #3
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    ill post up a pic in the morning

  4. #4
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    Click image for larger version. 

Name:	20140212_163922.jpg 
Views:	143 
Size:	148.4 KB 
ID:	26353

  5. #5
    you dont need that part of the loom when doing the engine swap

  6. #6
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    oh sweet, curiously do u know what it is anyway

  7. #7
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    also have this cut
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	20140212_173344.jpg 
Views:	113 
Size:	108.4 KB 
ID:	26354  

  8. #8
    Member Array
    Join Date
    Oct 2006
    Location
    Melb
    Car:
    P1.5 460F/350R
    looks like underdash harness. last pic is abs plug?
    S P A M | W O R K S
    With our special rotational tires, it will allow you to drive very fast. - JK Tyre

  9. #9
    it looks to be part of the rear wire harness

    top part thats been cut off goes to the Drivers door harness and bottom part goes to the rear of the car

  10. #10
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    old engine is out now trying to figure out wiring
    since these plugs are cut do u just cut the tape around my old loom and use my old door loom wires or is there a simple was that im missing haja

  11. #11
    Newcomer Array
    Join Date
    Oct 2012
    Location
    melbourne
    Car:
    dc2
    also im going from a 93 jap spec si to a 99 audm type r

  12. #12
    you only need to swap out the ENGINE HARNESS. Unplug it between the two strut towers and it comes out with the engine

    Don't need to touch the door looms, dash loom or anything else

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.