Hey everyone (:

I'm doing a y8 head swap on my missus car. I fully understand everything about the swap except how to make the vtec work with the p2k ecu.....

I have a apexi vafc2, obd1 and obd2 distributer and a y8 loom spare.....

Ultimately I would buy a jumper harness and re use all the y4 dizzy etc...but it's proving impossible to find out about that too....

Can I just get the p28 obd1 ecu and harness plugs, cut off the p2k plug, re wire the p28 to the d16y4 loom, re wire in the obd1 dizzy and run new wires for the vtec....????

Thanks in advance dudes!