Removing gears from counter shaft

[Dutchy1978]

Does anyone know how to remove the gears from the counter shaft of an Integra Y80 transmission?
I have ordered an MFactory Final drive gear set and need to swap the gears over. I have removed the nut but not sure how to remove the bearings and gears without damaging them.

Any help will be appreciated.

[bennjamin]

Use a bearing puller on the top bearing - the rest of the shafts simply slide off or require a few little taps with a small rubber mallet or similar. You can even just hold the thing upside down on a rag or piece of wood and lightly tap the back end and the lot will slowly slide off.

[Dutchy1978]

That's the info I am after. Thanks Ben.