DIY : CHECK ECU for j00 !

[AsH_]

ill see wat happenz...

[VTC-8OY]

okay i got codes:

3 MAP - manifold absolute pressure sensor

15 Ignition output signal

43 Fuel supply system

anyone can help me? much appreciation n

EDIT: PLEASE refer to my thread in Technical page

[XB-16-AX]

i got a code of 17 = VSS what could be faulty or needs replacement?
HELP NEEDED!!!!

[bennjamin]

i got a code of 17 = VSS what could be faulty or needs replacement?
HELP NEEDED!!!!

VSS = vehicle speed sensor. Its located ontop of the gearbox diff housing ~ pretty much right above where the 2 driveshafts meet in the middle. Check that its plugged in correctly...

[rnbguy]

ive got a honda EK and this is no where to be seen?

[bennjamin]

ive got a honda EK and this is no where to be seen?

the VSS ? Its a black plastic plug located ontop of the differential housing.
Right near the rear engine mount - It has wires coming out of it.

Or do u mean the ECU test thingy ?

[rnbguy]

i cant find the ecu testing thing on my EK either anyone?

[ekhybrid]

i cant find it too
can any1 confirm that the ek 1 is there?

[bennjamin]

i cant find it too
can any1 confirm that the ek 1 is there?

ive done 2 ECU tests on EKs - a EK1 and a EK4.

The Wire is located in the same place. Try and look up inside the back of the glove box etc.

[rnbguy]

see that strange i can see the three wire connector but no 2 wire connector around it at all....?
im just looking without removing anything (carpet, lids etc)

[bennjamin]

see that strange i can see the three wire connector but no 2 wire connector around it at all....?

try and look around the same area - should be there somewhere.
Here is the location according to the official HONDA EK guide -

[rnbguy]

think itll make it easier if i remove glove box?

i wonder how hard they are to remove