DIY : CHECK ECU for j00 !

**HyperZ** · 14-11-2005 01:58 PM

Nice DIY, does it apply to EK/DC's as well?

**bennjamin** · 14-11-2005 02:05 PM

Originally Posted by HyperZ

Nice DIY, does it apply to EK/DC's as well?

Yes , but please check with the location of the ECU connection - it maybe slightly different or a different location to my EG civic.

**YELLOWDC2R** · 29-11-2005 11:56 AM

My ABS light stays on and it register fault code 54. What's the error?

The car is 99 Integra Type R Aus Spec

**civ_sik** · 23-12-2005 09:59 PM

mine says 22 VTEC pressure valve

any ideas?

**ECU-MAN** · 23-12-2005 10:20 PM

you have a problem with your VTEC pressure Valve

**ECU-MAN** · 24-12-2005 10:17 PM

from the factory it will be plugged into a rubber holder along with the 3 pin DLC. if the last dude to play with it didnt put it back in there then it couls be floating around.

**Dxs** · 22-01-2006 05:06 PM

i have an ef8 with a b16a1.. which i presume is OBD0

so do i still pull out the plug and put in a pin to bridge it but instead check the ecu for a light??

edit: just tested it out... made no difference at all compaired to not being bridged.. engine like flashes once and so does the ecu light when key is turned to on.. i guess it is all fine then

**ECU-MAN** · 22-01-2006 09:00 PM

you go by the ecu light for fault codes, like you saw, one quick blink, that means there is nothing in there

**Cold Fusion** · 03-02-2006 02:18 PM

i have a da9, i was wondering, how do u reset the ECU after ive done the DIY ECU check?

thanks, im about to go do it, wish me luck lol

**Cold Fusion** · 03-02-2006 02:34 PM

i have NO idea where this green thing is u say where the 2 bit wire thing connects to, i searched and i cant find anyhting even romotly close to it.

where is that in a da9, does anyone know? and what colour are the wires for ours?

Thanks,