Hey guys
Im having a problem with my integra vti-R DC2, i cant shift my gear into reverse...it wont go in. All 5 gears work fine, its just the reverse. Any ideas why?
thx
yup, tried putting into first then into reverse...still wont go in, then tried holding clutch in and revving and tried putting it in reverse, still wont go in. Is the gearbox stuffed?
Yeah i have that same problem at times. But i think its normal.
What i do is if reverse doesn't go in then i:
Put it in neutral
Realise the clutch
Put clutch back in
shift between gears 3 and 4
then try reverese again
Then reverse works for me.
Sometimes i have to do those steps twice. If you try this and it doesn't help then i think you may need to get your gearbox checked.
nar wont go in damit, last night it did it but somehow i fink i forced it in lol and it was working again but now it wont go in again. i duno jack about cars but can i change the reverse gear or do i have to change the whole gearbox? if so how much will it cost?
nope, it like wont go in at all. gears 1-5 works fine. Like when trying to put it into reverse it goes in a tiny bit then stops, wont go all the way into reverse
Your gearbox will need a striping and only then you can identify what's wrong. I would say it's the selector inside your box. If your in Melbourne take your gearbox off and bring it to me i can fix it.
put it in third gear and pull the clutch half way out and then back to the floor (without stalling lol). this should get the gears in the box spinning and line up the reverse gear.
then try putting it into reverse. always works for me.
just putting the clutch in and revving the engine does nothing for the gear box.
Last edited by JasonGilholme; 18-08-2008 at 05:06 PM.
Reply With Quote
Bookmarks