hey
got my valve cover off. it's a h22a engine
i used spray paint stripper a few times and hosed it off with water. then i used an air compressor to blow water out from where ever i can.
now there's probably some water in the pcv valve hole and some under the cover which is covered in oil
what's the best way to make sure all the water is gone before i start painting the cover besides leaving it outside to dry over 24 hours?
i've tried removing as much oil as i can using a rag but there's probably bits in gaps here and there.
cheers
also i've covered my exposed engine with lots of newspaper sheets and closed the hood.
should that be enough to leave for a night or two?
keep in mind i don't park inside a garage, just under a carport.
Bookmarks