Dxs
24-07-2006, 03:05 PM
I have a b16a1 engine and plan to install an alloy intake pipe.
The problem is that the new pipe only has 1 hole for air/vacuum like lines.
Where as the stock piping has 2.
1 line goes to the cam cover for ventalation
and 1 goes to this other thing on the intake mani. (yellow arrow)
here is a pic i stole:
http://b16a2.kicks-ass.net/tech/EF9-B16A-dashpot.jpg
Any suggestions on what i should do?
All i can think of is that i get a breather for the cam cover.. but i believe that is illegal.
Also that black plastic thing in the lines from the thing on the intake mani.. does that need to stay? is it a valve?
The problem is that the new pipe only has 1 hole for air/vacuum like lines.
Where as the stock piping has 2.
1 line goes to the cam cover for ventalation
and 1 goes to this other thing on the intake mani. (yellow arrow)
here is a pic i stole:
http://b16a2.kicks-ass.net/tech/EF9-B16A-dashpot.jpg
Any suggestions on what i should do?
All i can think of is that i get a breather for the cam cover.. but i believe that is illegal.
Also that black plastic thing in the lines from the thing on the intake mani.. does that need to stay? is it a valve?