Help with Emanage

Hey im getting ready to install my emanage this weekend, but im lost with a few noob things. first up there is a black wire for ground, but there is another one with a brown strip on it which isnt labelled in the diagram below.

also, there are the 2 green and white wires with male bullet connectors attached, wondering how i am supposed to incorporate these.

AND last but not least, i have a SECOND yellow wire with a FEMALE bullet connector attached....wtf is this for? thanks in advan....ce (<-- lol @ mi car j0k3)

http://i161.photobucket.com/albums/t...an0001edit.jpg
http://i161.photobucket.com/albums/t...dwardMovie.jpg

The green and white wires are for the airflow signal. You'll need to cut the wire that leads from the airflow meter to the ecu. Then connect the white wire from the e-manage to the wire from the airflow meter. Then connect the green wire from e-manage back to the ecu.

The one with the brown strip your talking of is the throttle position wire.

I'm not sure what the 2nd yellow wire is for, could be the vtec solenoid sensor.

what colours are the throttle position wire + vtec solenoid wire on the factory ecu?

Quote:

---

Originally Posted by nick_sixx

what colours are the throttle position wire + vtec solenoid wire on the factory ecu?

---

shouldnt go by the colour of wire from the ecu as they might be different.
should follow the pins

Quote:

---

Originally Posted by nick_sixx

what colours are the throttle position wire + vtec solenoid wire on the factory ecu?

---

Grey and yellow. Can I ask what sort of setup are you after?

Quote:

---

Originally Posted by teaseR

shouldnt go by the colour of wire from the ecu as they might be different.

---

X2

that should clear things up

http://www.phearable.net/tech/wiring...schematics.gif

^^^thank you so so much :)

Quote:

---

Originally Posted by TypeS

Grey and yellow. Can I ask what sort of setup are you after?

---

just basic greddy TD04 setup for now until i can afford injectors+exhaust+clutch, then ill turn it up to ~10/12psi

that a greddy kit???

Their the instructions for the old FCU, the next page over has the emanage instuctions.

aLso, if i remember right, the pic is looking at the plug from the wire side, not the pin side

also dont use colours, use the positions