ITR Cams, Fujita CAI?

Motor is not faster, motor makes more power.

fujita cai is hectic.

buzz my friend you have been ill-informed.
in terms or power potiential b18c2 is just a small potatoe compared to the b18c7.
besides b18c7 will chop a b18c2 anyday any time given same mods etc...

Quote:

---

Originally Posted by buzz

At the moment im running an Apexi Power FC and CTR camshafts, to me works great against a stock vti-r.

but from what I heard that the b18c7 is not faster at all compared to the b18c2.

---

Thats not entirely true...

Are you driving Eric's old car?

b18c7 with bolt-ons will get do a 13sec pass down the 1/4mile.

we shall soon prove this in our dc2r.. :p

Quote:

---

Originally Posted by Benson

b18c7 with bolt-ons will get do a 13sec pass down the 1/4mile.

we shall soon prove this in our dc2r.. :p

---

The 13sec EG map is converted ready to go intothe ECU and its setup for both S200 and S300 configrations so we will back to back the ECU's on Wed.
Regards Dyno Dave

Quote:

---

Originally Posted by DynoDave

The 13sec EG map is converted ready to go intothe ECU and its setup for both S200 and S300 configrations so we will back to back the ECU's on Wed.
Regards Dyno Dave

---

Very nice... headers went on today with the top fuel exhaust system...

lighten flywheel and clutch was changed as well.. :)

New rear engine mount...

Took the car for a spin to test out the new set-up and we were very impressed!!

Quote:

---

Originally Posted by Benson

b18c7 with bolt-ons will get do a 13sec pass down the 1/4mile.

we shall soon prove this in our dc2r.. :p

---

WTF.. i thought the ITR was to remain stock :p

Quote:

---

Originally Posted by BlitZ

WTF.. i thought the ITR was to remain stock :p

---

Its still stock man... :p same bolt-ons as the yellow car..

Quote:

---

Originally Posted by Benson

Its still stock man... :p same bolt-ons as the yellow car..

---

And all bar the exhaust the boltons are Aussie made and developed.
Regards Dyno Dave

in an effort to seek the Plazmaman out - i found this:

http://www.plazmaman.com/shop/index....tem&itemId=144

$395 or $325 non-polished, but unsure if AUD???

good value for money i guess if it is AUD?

i am currently deciding between INJEN CAI vs AEM V2...

Quote:

---

Originally Posted by EG5

Try to run skunk2 Intake manifold 1st .
Best bang for bucks

---

i installed the skunk2 manifold .. felt like my car went slower.. do i need to tune it?