Printable View
Ok.. Ive got a trsut sandwich plate..
The sensor holes on the plate are massive and are in metric.
I have guages with sensors in 1/8 imperial..
Where can i get a fitting to plug the sensors into the plate.. (ive already been to autobarn, supercheap, earls and pirtek)
And no i do not want to T off oringal oil pressure sender, drill hole in pan or buy a new sump bolt...
:thumbsup:
Thanks guys..
Its the same adapter you'd use to replace the oil pan drain plug. Its on the greddy site somewhere. I used a HKS one. I think they're the same
i got the sandwich plate here and a spoon sump bolt.. the sump bolt is smaller...if it was the same i would be getting vdo sump sender..Quote:
Originally Posted by weezer
Let me check the website out..
Drop by Pirtek...I go to the one on the way whetherill park, smithfield(?) very helpful.
Quote:
Originally Posted by BlitZ
There are different sizes. You just have to find the right thread.Quote:
Originally Posted by BlitZ
Yes whetheril park Pirtek. Im sure you'll find the fittings needed there.
dont u guys read eheheh..
Ive been there and so as earls.. heheeh no good
new sandwich plate FTW.
Quote:
Originally Posted by BlitZ
12xP1.25 OIL ADAPTER
Temp. replaces oil pan drain plug
16400713 10.50
14xP1.25 OIL ADAPTER
Temp. replaces oil pan drain plug
16400714 10.50
18xP1.25 OIL ADAPTER
Temp. replaces oil pan drain plug
16400721 10.50
its one of those heheh think its the last one
No, it takes too long, I just read the first line and the last.... :pQuote:
Originally Posted by BlitZ
Ok, Olympic Instruments - They sell VDO units, they might have the right adaptors. You have to look up the yellow pages, they're in Ryde...
daniel la
autobarn should have the vdo sump plug sender adaptor for under 10$
i may have one lying around im not using
depending on where your sump bolt is on the sump it may not be problem
1/8NPT npz
its just too messy.. its not something i could live with for the long term.. ...Quote:
Originally Posted by iced
I am thinking about removing it and making a bun in sump instead...:thumbsup:
where is the sump plug on your motor?
angle to the side near the bottom or what?
if the sump itself will still be lower than the sender with adaptor attached to the sump bolt fitting then you wont have a problem with it getting a bashing
thanks for the the tip vinh :thumbsup:Quote:
Originally Posted by weezer
Steer gimic... have u got also got the trsut snadwich plate?Quote:
Originally Posted by Steer^Gimic
Ive found a product needed to use the 1/8npt onto it:thumbsup:
Let me know if thats what u need..
its just ugly and inconvenient when changing oil..;)Quote:
Originally Posted by iced
less chance of dropping your nut into the pan
lol
its gonna be welded in man... the only thing i would drop in the pan is a piston.:thumbdwn:Quote:
Originally Posted by iced