Hey guys, so i have done a fair bit of research towards this and it is my understanding that I can get this to work. Just wanting to know if anyone else has opinions or experience with this...
Hi guys, so i am rebuilding my D15b4 and the easiest kits to get a hold of are the ones on ebay in the US. In the title they all say d15b rebuild kits and list D15b7, d15b1, d15b2 etc. Is the...
So I'm looking at some headers for my civic and I've seen on ebay some TOG headers, they are designed in australia and made oversees, But I can get them for $220 off ebay, where as xforce are like...
Hey guys, looking at doing the carb mod on my d15b4 but in the mod write up I never saw any posts on what size ended up working in the end. Does anyone know what brand/size ended up working best?
Okay, thanks for the figures mark, and yeah the D15B4 is an awesome little motor. The amount of engineering they put into it is great, the ED civic in general actually for an early nineties family...
I'm using the head and bottom end off my original one, and the carbs and intake mani off the one I purchased from you, and it has been working great. Had done 2500k's on it before this problem. I'd...
That's my best guess at the moment as well. Should probably also mention the ignition leads and spark plugs only have 1500-2k kilometres on them. I'll clean out the bowl and jets and do the timing...
So did a compression test, left to right it was 200psi, 190, 180, 190. So third cylinder is the only real concern there, put a teaspoon of oil and redid the 3rd and it went up to 200. SO makes me...
Okay so I let someone else drive the car and they did a pull to 6-6.2k in 3rd or 4th gear and after that we noticed that the car now misfires, first noticed it taking off at the lights. The car has...
I am having a lot of trouble finding my thermo fan switch. It is not where the haynes manual says it is. Although the manual seems to focus on EFI engines, I have the D15B4 in a 1990 ED civic. The...
Ok, thanks for the reply, that is around the temperature I would have expected. I'll test the motor and see if it is at fault, hopefully it is just a loose wire/connector to make life easy.
Just trying to figure out if my thermo fan is working or not, using an infrared thermonitor I measured the thermostat at 102 degrees and the thermo fan didn't turn on, I would have thought it would...
I'm curious if you have checked the lug nuts again? Check each one for cracks (even hairline cracks around the lip) as it could feel like they are done up tight but still be loose under braking...
Decided against it as there are mixed opinions about it online. Just going to get some of that castrol 20W-50 GTX oil designed for old engines. Will run that while I am going for roadworthy. Then...
Hey guys, at the moment my car releases a tiny bit of black smoke when letting of on the accelerator when in the 3-4000rpm range, I am fairly sure that the valve guides are worn. But haven't done any...
Ok, so basically run power down drivers side. Then I will probably run speaker wire down middle just to keep the lengths similar and so there isn't as much noticeable bulge under the trim/carpet....
That was my understanding of it, but I was confused because I have been told by mechanics that the choke can not be replaced in these engines. Holding the level/pushing the rod going into the black...
Ok, so basically my engine is idling at a high RPM (2000ish) and when we push this mechanism down the idle drops to something closer to normal (750-1000). Although there is nothing connected...
