Usually the bseries suffer in those synchros 2nd and 3rd . I would follow Sam's advice for starters and if not then a gearbox rebuilt will be needed . I would suggest to rebuilt the gearbox instead...
You say in your first post that you have changed them ! If they are faulty then they are under warranty . After the bleed did it crunch again ?! When you state crunch , how many revs did you have...
I can supply you with Clutch Masters clutch kits . Clutch Masters are 100% USA made and they are the record holders in the USA and Europe . Some cars that use Clutch Masters are the DriveShaft Shop...
That is not weird . This can happen to any brand that is why they call it material defects and that it why manufacture warranty is given . It might be the whole kit . I have kits that have...
It sounds most likely as your input bearing is starting to play or your 1st gear needle bearing . If you want and you are in Sydney , you can come over so we can have a look at it .
As chez00 suggests it might be the fork(s) . I hav also seen the input bearing been completly distroyed as well as the last Kseries (6speed) that I rebuilt the c-clip was half broken and the...
cceebz , is the gearbox still on the car ?! If so you could bring it over , so we can go for a test drive and go from there . As chez00 says it will be really expensive changing all the gears except...
I am just reffering to your comment that some other workshops charge 2K and I am just suggesting in similar situation , to talk to Josh , cause he does a really good job and doesn't over charge . I...
Natey , I would suggest then to do all the steps that Sam has suggested as they are the most cost effective and then if it still continues you will need synchros (suggesting to also change bearings ,...
It's 99% the synchros , which it typical for this gearboxes . If you are in Sydney , come over and we will check it for you and give you a full quote . We do all the time gearbox rebuilts .
You can't buy the shaft by it on...I can supply to you a most Final Drives up to 4.928 . If you want at the time you can install carbon synchros , LSD and so on ...If you are interested send me a pm...
As you have written it has always been difficult to engage reverse and on high RPM 4th crunches . Crunching 4th or any gear in high RPM in the Honda gearbox world is synchros . But in regards of the...
Have you taken apart the gearbox ?! Do you know what FD it is already and what you want to install ?! Because there are differences on what series (B,K,D etc.) and from Type R to standard etc.
...
We can offer you a Clutch Masters clutch kit that will easily handle that power . Clutch Masters are made in USA and hold all the Honda drag records as well as they were the winners of Fomula Drift...
You can use an adaptor and make do F2B meaning using a Bseries gearbox , which I would recommend as there are a lot of parts that I can supply to you to be used with any set up . Also from my...
There is a gearbox oil filter in the AUTO transmission not in the manual .
I do not know anything of a recall but because we do a lot of gearbox rebuilts in store and we also suply Carbon Synchros...
I don't know anyone up there to suggest to go and see the car .
Have you replaced your clutch ?! Has the previous owner replaced it ?! If so that is when your gearbox oil was also replaced .
Josh has a point with the blades . There are some that are designed only only for push and some for pull . But in general NO , it will not cause you any problems . There are cars from factory that...
