Search:

yeah i understand, ill plan it out and see the cost of everything and start from there, thanks.

Thank you for your help guys! really appreciate it! ill probably run on pedders shocks instead of standard just for the safely and smooth ride :)

But is it going to damage the shocks right away?

Is it okay to run aftermarket lowering springs on standard shocks? like TEIN S-Techs?

Just wondering, If i install Tein S-tech on Standard shocks. Would it affect or damage my shocks?

Apparently those TEIN's were made to fit the Stock CL9 shocks and doesnt damage it.

Please...

Alright ill get my fuel filter and trans fuild changed :) Thank you so much !

I've got a Automatic Euro, i was told it was the coil pack, but if it was it would of died out straight away, i changed sparks so it cant be a misfire, and so far i got told it was Intake, Throttle,...

I have a issue with my Euro, While acccelerating sometimes around 50kmp/h, it seems to feel as if im on a bumpy road, but im not :S so its basically the acceleration is chugging. Any suggestions on...

sorry forum police all fixed

i have purchased a eg with b16, i got it blue slipped and he put the b16 engine number on the blue slip, previous owner doesn't have proof of purcahse for the engine ,

i went to rta today and they...

hi where are you located? looking for honest mechanic in sydney

99.9% this item is fake, if you purchased it from sdwayz on ozhonda it's fake 100%

how does the asr brace,sway bar hold up and gabs?

it has been done cost about 500 bucks, with my own labour

5by114

bigger brakes, more wheel choice

who knows mate, this is e diagnosing it could be anything, fuel rail could of sprung a leak, and caused it to spread all over dirt and grime, i'm not being stupid either.

thanks

any chance you can be more precise? unleaded fuel is an oil as well, engine oil, power steering oil, grease oil? etc thanks

best thing to do first is wash it down, and keep an eye out for the leak everyday, check where is wet, from top to bottom

no incorrect, if the above was faulty it will not engage any gear,

so are you're trying to say everything i have listed above is installed correctly? + the gears would engage before?

then how...

no i don't think there is, though just asking to make sure as i'm only guessing the person who performed this job must be a "diyer",

bearing isn't seized?
put bearing in the right way?
the fork...

just some general info that members need to help resolve this problem for you :

1.did you put the linkages on right way including putting the pins in?

2. did you put all the gearstick bushes...

Can you select gears without clutching?

You should of locked it in gear before box back in. if you can't select third gear try bleeding the clutch system again, or check the clutch master isn't leaking which is common problem. Also check...