Can anyone tell me what size the outer cv joint is on a type s? I know the US rsx-s is 36mm nut but I can't seem to find out if the aus type s shaft is same (36mm) as the type r.
first thing i would do is make sure correct oil is being used, or just do an oil change with correct oil grade or a little thicker and see how that goes.
your toe on the rear changes as you lower your car. so if you have no more adjustment toe in or toe out you may just need to lower/raise your car a bit or maybe even get adjustable toe arms if your...
K24a3 base, The heads on these have just as much potential as any k20 head, Just needs K pro ECU to take away down tune. If your looking for one get a 06+ engine because the cams were improved.
...
(biased opinion) so your paying 4k extra for a vtec head, how much can u get a vtec head for? i don't see how that's best bang for you buck. The gsi is less likely to have been thrashed as well.
Not long ago i put dc2r sway bars on my dc4 with asr brace, The car corners so much better and a lot of the body roll was gone even with stock spring rates. The thicker rear sway bar keeps the car...
I don't know how they are doing it with k series. It would be pointless for honda to have a bigger drive axle if the spline of the shaft was the same as a 32 where it meets the outer cv joint.
Atm i still have the original engine b18b so i don't think i can use dc5r's because they would be wrong length? and the outer cv would be different inner spline not fitting on my original shafts like...
I have standard gsi drive shafts which are 32mm nut. I was hoping there was some other 36mm outer cv joint (the part that goes into the hub) that would fit on my drive shafts. Im starting to think my...
I am trying to find a set of 36mm itr's. After taking of the crv outer off and it didn't fit i would assume the dc5r outer will be the same and not fit on the shaft.
I installed jdm dc2r suspension (36mm) on my car (dc4 integra gsi) and i can't find a drive axle that will work. I tried taking a crv 36mm outer off and putting it on my shafts but the inner spline...
On newer cars whenever a airbag is disconnected at any time the airbag light will come on until cleared. The guys must have forgotten to clear the fault, no big deal.
im 19 and have NO experience with gearboxes when i fixed mine up. As long as you have a little confidence with your hands and some patience theres no reason you can't do it yourself.
...
Input shaft bearing most likely, I had the same noise on my d15b7 so i pulled my gearbox out and pulled it apart. When i spun the input shaft bearing i could feel a slight roughness compared to the...
