Tip of the hat to you Mr Pacman,
Though I'm certainly not a turbo H22 fan,
This has to be one of the best executed, thought out & thorough turbo setups I've seen in a long while.
Nice.... very...
You're doing it wrong.
+5 is the piston dome capacity
Size is 81.00 (Std bore)
With given comp height on an unmachined B18C2, the compression would be 11.2:1
- Using OEM head gasket.
Take 0.005"...
I would, as the ECU is a switching earth.
But you could cheat & run a wire from the fan switch - positive side to A12
Then the factory relay would be operational.
& if you spliced it, the fan...
Further to the Drift product there's also the Billion VFC's (& don't have an S300)
http://www.nengun.com/billion/vfc-max
http://www.nengun.com/billion/vfc-elm
Check ignition switch
Check main relay
Check fuel pump relay
Check engine earth
Oh & make sure the back-up battery power to the FC is just that, not accessory power.
It'll work no problem,
Also your figures to compare are not quit right.
Your OEM figures are at 1mm lift & the BC figures are advertised.
The actual difference between the cams is not that great....
The HD is a standard clutch with heavier clamp laod,
The SO comes with an uprated disc as well as the heavier clasmp load for approx $15 more.
It's a better clutch in that it last longer & can take...
Actually at idle you're more likely to hydrolock than if you drop it back to 1st & floor it through a deep puddle.
The engine can injest shitloads of water at high rpm the reverse is true of low rpm...
9 time out of 10, the S300 delivers a better result. (Better cold start, idle, sharper, crisper & 2~3 hp more everywhere)
Though on one occasion I had an FC outpower an S200 on a DC2R
(But I...
Having pistons under crown cooling jets is considered to be an improvement over having none.
(B18C vs B18A/B20B - case in point)
Generally the only reason you might delete them is due to exessive...
Having tuned all of the ECU's mentioned, it seems to me a no brainer to move to a Haltech Platinum Pro system.
Yes, the M48 is good, but it can't do VTC.
Moving to an M400 will work, but good luck...