Oh yeah, forgot about that. Don't remember what size drum rear cars have, 13/16" or 7/8? Seems to be mixed opinions on whether people felt like they really needed it.
At least for the B20A6, wouldn't the larger initial buy-in cost on a B16/B18 (or even a K24A3 as mentioned) be easily offset by the power ceiling and ease of access to off the shelf aftermarket parts?
22mm front sway (assuming that's what it has) and EK4 rear isn't a bad combination. Not a bad idea to track it first and see how it feels and what needs improving before pulling the trigger on...
Jubilee clamps aren't really an upgrade over the OEM style, though they do make it easier to remove the ones in tight spots. If you're going to the effort of cleaning the throttle body make sure to...
Still quite a lot actually, EMS is very reasonable. Also never paid more than $12 for shipping last year regardless of order size, but they have dynamic rates now.
You can save a lot of money if you order from online part suppliers such as Amayama, I just compared a few of those to what I had priced up for my own rebuild and it's approximately a 30-70% saving...
Because that was the last year of production. The fully mechanical 4WS system that the article refers to was also only present in the third generation model.
Short shifter is fine with exhaust clearance, although I had a Mugen catback installed already when I was putting the shifter in if that changes anything. I don't think the OEM knob would absorb that...
I personally like it. I've tried a few different knobs, from light ones like the Carbing and Spoon Duracon, to OEM Type R and ranging up to the Circuit Hero ones (although you can get heavier), also...
I'm looking to install an ITR intake arm + box that I had sitting around to replace the stock intake (panel filter type with resonator). As such, I was wondering how people have gone/would go about...
Nice pickup with the NR10s, 14s are usually ok to run with 262s. So did you find that the rotor should be spaced 3mm like the 282 swap on Civics/Integras etc or it just needs to be spaced by a...
CTR cams = 00-01 DC2R cams. You will also need the associated valve springs for at least the intake side. Cam gears will be the same, valve springs will be different.
