Search:
Type: Posts; User: dynosaur; Keyword(s):
Search:
Search took 0.02 seconds.
-
-
Yeah, I agree with you. At this stage, I need to get a set of BB4 rotors to try fit and see how it goes.
does BB4 hub centric diameter is 64mm or 70mm?
thanks :)
-
Will I need to machined a couple of mm off from the brake bracket for align the rotor? By how many mm?
-
yeah I understand I need prelude rotor, but which year of prelude? (93-95 BB4?)
Will the prelude(BB4) rotor be DIRECT Bolt-On without any minor modification? (eg: redrill PCD and hub centric...
-
becoz I got a limited budget, therefore I have to DIY to keep the cost as low as possible.
plz understand...
-
yeah I understand I need prelude rotor, but which year of prelude? (93-95 BB4?)
Will the rotor be DIRECT Bolt-On without any minor modification? (eg: redrill PCD and hub centric diameter.)
...
-
my car is JDM DC2-R (96 Spec), the PCD is 114.3x4,
Now, I would like to upgrade my braking power. therefore I will go for the Bang with bucks setup.:p
As far as I knew, I need OEM ITR calipers...
-
hey charger,
how much do u qoute for the seal kit ?
-
Thanks for the part numbers :)
-
ok I will try, thanks for that :thumbsup:
-
yeah, but i get it from another guy(cheaper price), which he ask me what part number of those brake pads. :).....
-
so what is the part number ?
-
huh!? VTiR PCD is 114.3x4? I though it was 100x4.... some1 can verify it ?
thanks :)
-
just now i went out to check my Rear caliper, I found out my caliper is 7CLP13S.
so what part number of the (Rear)brake pads I should get?
-
-
yes, 114.3x4. But the PCD is not the main issue in this topic :)
I am looking for the part numbers :)
-
1st I have to make it clear first. My car is JDM DC2-R (96 Spec)
some1 told me the
DC2-R (Rear): 43022-SV4-A00 (for nissin 9CLP-14S caliper)
DC2 VTiR (Front): 45022-S04-V10 or...
-
Hi every1,
I would like to get the OEM part numbers of these brake pads. Any1 can tell me? Thanks alots :D
DC2-R (Front)brake pads :
DC2-R (Rear)brake pads :
DC2 VTiR (Front) brake pads :...
-
:confused:which year/model of prelude ?
-
does NSX caliper rebuild kit can get in Aus ?
(as i know the NSX caliper is twin blocks, correct me if i m wrong)
-
my car is jdm dc2r 96-spec (262mm),
do i need to machined 2.7mm off the caliper as well OR just bolt-on ?
how about if I add an 3mm inner spacer instante of harming the braket ? (like what...
-
are there going to be any different with or without inner & outer pad shims (brake pads)?
-
can u be more specific explain on where are we need to use the 'pink' colour grease ?
-
u should go to WTB section.
mod, plz remove it
-
will we need to wheel alignment again ?
|
|