Go crystal vision. They are less ugly and yellow when compared to the standard globes and shouldn't have any trouble from the cops with them since the light they produce is white.
If the measurement of speed was accurate it means I have a longer 4th gear. For example At 7000rpm my car will be travelling the same speed as your car is...
According to Tanabe, their NF210 lowering springs are about 10% stiffer than stock. They rate their NF210 springs at 5.6 kg/mm front and 2.5 kg/mm rear
...
if you want to use the RBC with the stock intake, gruppeM intake, mugen intake or any other intake that makes use of the stock rubber intake arm the solution is simple. Buy the intake arm from the...
The adjustments I made to the throttle settings won't effect power output. It just puts less strain on the drive by wire motor really. At 88% TPS the butterfly is actually fully open. At 97% it is...
^ when you take off the front part of the intake manifold, shine a torche down just to make sure there is no ledge anywhere. If there's no ledge or lip, there's nothing to worry about
Sometimes the gasket won't line up perfectly when you have it off the car. If you have some free time I think it might be worth checking that there is no ledge or misallignment between the intake...
Yea, I used to chirp/wheel spin much easier when the car had stock suspension. With the softer stock suspension the front of the car will lift off the ground very easily under acceleration which...
Yea. Previously I had to shift at redline to make the car feel fast. I can now get that same sensation of power shifting at 5000rpm. It's now a very torquey engine. It feels like driving a 6 cylinder...
thanks yfin! It finally feels like all of the effort has been worth it. Based on some rough calculations the car should have over 175kw and 280nm of torque if measured at the flywheel.