hey guys im wondering if anyone has done the front end conversion or knows if it ill fit up.. from wat i see the gaurds should line up but unsure of the bonnet bar and lights any help would be good...
rod knockin did u put the correct level of oil in it ??? did u leave somthing unplugged?? i hav a d16y1 in my car and i have never heard a knock even under the punishment i give it.. just check all...
the covers are more of a waste of time my suggestion is to take them off clean them with brake cleaner or carby cleaner get some red caliper paint and spray them then find some brembo stickers
or you could go with some ghetto steal rods made up amd brackets and solid top mount to the hight you want imnot sure its safe but you want it low and not to bounce and hit ground but it will be a...
did they fill the gas to the correct amount did they change the the reciever dryer.. if all this i suggest possibly changing the ac compressor and regasing it
check your plugs hav the correct gap and correct plugs for ur car.. check the timing also. maybe clean ur throttle body and clean ur pod then if it still runs rich then start replacing things.. as...
yes thats right the gaurds hav to be modified or swaped to fit them.. centre console can be swapped and maybe rear seat base only.. carpets can be aswell
could be vtec solenoid, vtec pressure sensor etc or even dizzy giving way my old 4th gen did this i had to replace engine loom dizzy vtec soleniod and ecu
is urs manual or auto
the moderators are here to keep it under control and keep the posts in the CORRECT sections, if u get an infraction or more u hav done something wrong repeatedly and u didnt listen as far as being a...
i hav a 4th gen bb2 si with a jdm h22a conversion in it with konieg hotswap 17x7s, half custom extractors, aem cai, a tanabe front strut brace and a drift cannon lookin 2 sell maybe.. the 4ws is a...