The low compression may be due to fuel wash on the cylinder walls.( over cranking with no spark but injectors still firing fuel) Easy way to check this is oil seems.thinner than usuall or smelling...
What are you installing it too eg or ek chasi? As the timming side mount will be diff. As I can see if its for a eg/dc2 its the old.mount now there is a revised timming mount
Skunk 2 manifold is over rated.(unless you want the bling factor) you can either modify your existing one by gutting the butterfly on your existing one with a spacer..
Also the k2h adapter is...
i was running a inovative lc-1 on my jet ski. Had motec and quite a few other mods. and the fix for the bosch bung failure was to install a heat bung. ( looked like a spacer i guess) and this...
nice build,
have you any work to the bottom end, i have read quite abit that the h22 hates boost especially in stock.form rings give way followed by cracked sleeves,.
but a built sleeved engine is...
U don't need to have a booth for sandblasting,
All you is access to a descent air compressor, a hand sand blaster ( super cheap have them.)a garage that you can line with some tarps to stop...
H22 does not need to rev its ass off like a b series to make power rev @ 7800 is ample. Its called tq. Just call for the correct engine combo. H2b setups are reving @ 7500-7800 and running 11sec +...