Google QM3 repair, if you have some soldering skills you can likely tackle this one yourself and save some money aswell as gain some repair skills. Good luck
What exactly went bad in the gearbox? Input shaft bearing possibly? By the looks of things there could be several causes.
1. Pressure plate is clamping unevenly due to internal fault (less likely...
The fascia kit will work fine, you just need regular wooden or plastic speaker spacers and screw them into the steel in place of the original speakers, keep in mind you may need to trim the factory...
It is highly unlikely that the o2 sensor is causing you these issues. It is possible that the exhaust shop has "tugged" on your o2 sensor wiring and possibly caused something else to come loose. You...
Try reset the timing first since it's free and it needs to be correct regardless, does anyone know if he has an interference engine or now, not sure what he has in there. If it's not that it will be...
your problem is the grounding bolt more than likely on the thermostat housing is loose or has corrosion, Remove the bolt, check the crimp terminal and clean if needed and re tighten.
Thats what it sounds like, had a similar issue once when i got my car back from repair shop, they put the timing belt off 1 tooth and it would run sometimes, and other times run really bad.
Not that i have ever experienced. As for the bouncing tacho, check that the grounding bolt on the thermostat housing is tight and check the crimp itself, also check that the ground strap on the...
but a set of integra vti-r seats, there perfect for an eg and the bolsters hold you nicely, see if you can get the rear folding back seat too, also perfect fit and nice and black
check the speedo connection, its a plug in the top/back of the gearbox basically directly behind/under the starter motor next to the rear mount, not hard to get too at all, just unplug it the plug it...