Search:

Ok thanks, will I still need an a2 oil pump if I'm not redlining past 8k

Got my hands on a cheap set of k24 CP 9.0:1 87.5mm pistons, Is it safe to bore +1.5mm on stock sleeves? I'm planning to run 12psi on a k20a3 with k20a2 crank and forged rods.

Also will these...

Deciding not to sell my k20a3 dc2, instead I'm going to build my a3. I know the a3 gets hated on a lot but I want to keep the a3 block. I am putting a list together on everything I need to make 450hp...

That could be it, the original colour was maroon, but I've just painted over light grey primer, I might just have to fork out the $350 to get it done professionally...

I resprayed it myself, the bumper is just sitting there it isn't bolted up, could it be the original respray has faded a bit?

They both have the same colour code Y-56, but I recently resprayed my front bumper and I asked the paint guy for Phoenix Yellow Y-56 because that is what my car was resprayed, but they said the only...

Just started it this morning after driving it down the road and the cel came on again, got home and check it, p0134 Air/Fuel Ratio (A/F) Sensor (Sensor 1) No Activity Detected, has brand new iridium...

I finally got around to replacing my Primary o2 sensor, drove it for around a month with the cel light on, and I think it was just running rich, black smoke on high revs and sounds like it was...

Clutch: Competition Clutch K-series Stage 4 Strip Series 1620 Clutch Kit
Fly wheel: Competition Clutch K-series Ultra Lightweight Steel Flywheel
The car does have a quite whining sound when...

I have a heavy duty clutch installed and when the car is idling sometimes your can hear a grinding sound coming from the clutch, also when the clutch starts to engage there is a pretty loud grinding...

I'm just wondering if its worth putting a k20a2 head on my k20a3 block, will I need to work the block because of the lower compression? Will I need a new gearbox? Or could I just swap the internals...

Might be buying my cousins B20/B16 ek civic (vtir) and was wondering if it is legal to drive them on your p's.

Thanks

Thanks, do you think its safe to drive home?

Its a B16a it happend out of the blue when I realised the car was shaking alot. I pulled over and the idle was really rough, it sounded like the Subaru engine, and it would give off a small backfire...

Lost my last black key.... :/

I have a 1996 Ek Civic and I lost the white chip that goes into the key... it was my last black key and only have a red key left, I took that into Honda and they said they need a black key as well? I...

Which do think would better suit an EK hatch? I was going to custom make one of these:...

Yea I would like to stick a nice turbo on it, but you guessed it, I'm on my P's. Does anyone know any reputable Honda engine builders around Sydney/Western Sydney?

I added everything up to build the head, it seems alot cheaper to just go b20 bottom (or Frankenstein or something?) and my head, using some b16b/b18c internals? would that be better?

I'm wanting to upgrade to stage 2 cams. I already have I/H/E. What else will I need? Valves and Valvesprings? Retainers? Throttlebody?

Also what is a nice affordable brand? I have been looking at...

http://www.hondapartsnow.com/genuine/honda~cover~71504-S2A-000ZD.html

This has probably been asked millions of times before, most people say it's a matter of opinion and some say it's to do with the climate.

Just wanted to know in your opinion and experience what is...

I wanted to remove my rear wipers on my ek, will bring any attention? Is it legal?

Thanks!

You get get the cheap one on ebay (Excatly the same -the carbon fibre): ...

I like the CBR125r, its looks really neat too