Search:

Sandown Maserati Car Club Sprint 11/04/2015
1.27.2 - new p.b

Hi guys looking for some info specs.
Can anyone give me the shoulder width ( width across face of rod - i.e. looking @ rod front ) of an std 138mm Type R B18 rod.
Thanks guys

Sandown Alfa club sprint 21/09/14 ( official results on natsoft )

1:27.54 - new pb

looking to buy a set of B16b rods - 142mm ( stock is ok ). Searched everywhere but seem to be coming up short. It seems to be the only Honda B appreciated series part that is hard to get after...

So no one ?................................. !

Hi guys looking for some info on what is the best way to go about re sleeving the D16a8 block with 78mm sleeves. Not too sure about how to go about it. I read the word Darton a lot ( they must be a...

Just about to upgrade my rear rotors/calipers to a 260mm conversion( using rear rotor off an mg). I currently have 280mm rotors with a 1" m/c, no booster. Have been using a 2040 prop valve - work...

Lowered my P.B. @ Sandown today by 0.7 - results on natsoft (HSV owners club )
New time 1.28.07. Checked my eclectic lap on the racechrono - Says had I got my shit together the lap was a 1:27.90 ...

Be interested to read everyone's thoughts on this. Thinking about upgrading to a legend twin piston caliper set up. Any one had any experience with the legend calipers ??? please fell free to...

Big Shout out to everyone who put on the H Nationals - should be very proud.
Been 13 years since i have competed @ Winton.
May 2000 - 1.45
April 2013 - 1.42
dug out some out results to see how...

quick time - where did you find the xtra second. good job

Good job dude - well done

Unfortunately I don't. Would be a useful tool to have & see where I am making my mistakes. It's on the to do list though

Go to www.ffcc.com.au & download the entry form. I think yesterday was the last day for the cheaper entry fee. Cost to run the day for late entry $250

FFCC are holding their annual Cupday @ Sandown this Tuesday ( 6th nov ) anybody entered to go round 'n round or maybe just going for a look see ?

Toyo 888 r's

Winton long track 1:39

See below - N/A D POWER !

Thanks for the info. I have used a power-coil kit in a stud repair before - no problems. Motor is n/a not boosted

Thanks for the info. I'm going to use a spare head I have as a jig to ensure that both the holes are drilled & tapped square.

Hello everyone. I have come across a damaged thread in the block for the head blots. Looking to carry out a timesert repair ( head has to be removed ). Looking for any tips/info from anyone who has...

Remember seeing this car @ the workshop - BTW any handling questions................ pick up the BAT-PHONE & give me a call. Happy to help.

I'm with Garry. Fitted a KAAZ diff to the CRX. Instant 2 sec lap gain @ Phillip Island with no other mods carried out.

Hi everyone. Can anyone out there tell me the big end thickness of a D17 connecting rod. Measurements in metric if you've got em.

Just wondering if anyone can reccomend where to purchase a set of 4-1 headers for my D16a8 CRX motor. I realise that doing this will result in a loss of torque down low, but being a circuit racing...