Thanks dorikin, I changed the steering boot today without removing the ball joint. There are plenty lenght to unscrew the rack-end and no problem to thread the tie rod back into the rack end when put...
Just a noob question, Can I turn the steering wheel all the way to one side (the side I change the boot) then hold the tie-rod with one wrench, and unscrew the rack-end with another wrench. Will it...
I'm not sure about Accord Euro. But my Civic is 160K Km on the clock, but still running on the 1st (Originnal OEM) set rear brake pad. It's still have about 1.5mm left. The front is on 3rd set now...
Check your brake pad. May be it has been worn out. It happened to my car. The warning metal piece scraping the disk. It sound like you put stick into the spokes of spining bicycle wheel. Some time...
I'm not 100% sure it is causing any damage. But by reading and compare the "Part Numbering System" http://www.ngkspark.com.au/sparkplug.php# . They have the same thread diameter (14mm), thread lenght...
Just use aluminium foil or newspaper wrap or cover surrounding area (hoses/firewall/engine/… around it) and spray it then use brush to touch up unsprayed area. Don’t worry doggy job because by the...
I bought this one few months ago and installed it my self. It's good and very nice. I ran the display's wire along the roof and stick the display unit on top of the rear view mirror....
I believe TX valve is heater valve. It used to open or close coolant flow into heater core. On my civic it is in the engine bay near middle of fire wall. Just trace the small radiator hose from...
On park plug lead (at the corner) there are little hole for air escape when it expanded by hot temperature. That hole may be blocked and hot air can’t escape so it push the lead popup. Use little...
The only way you want saving $$$ is open the open the timing belt Upper cover and inspect it for any cracks, missing tooths, oil or coolant soaked by rotate the crank pulley anti clockwise. I changed...
Just before remove the dizzy use pen or knife mark a straight line across dizzy body (metal part) and the engine. Also remember mark the position of the DISTRIBUTOR IGNITION (DI) ROTOR pointing to....
I alway marked the dizzy before I tooke it out. It wasn't happen to me so I don't known, anyway maybe the are bolt marks left on the dizzy body. Try to adjust dizzy so that the bolt alight with it...
Before remove the dizzy use pen or knife mark a straight line across dizzy body (metal part) and the engine and when you put dizzy back on adjust the dizzy so that the line is alight.
If you want to known the Kms Meter Genius or not check the Kms printed on the invoices (it should be printed on every service invoice) and Log book. Also get Honda service centre a call (that service...
Use small flat head screw driver to pry the speaker grille off (there are small gap like this [ ) there are 3 screws for the speaker and another 3 crews for the panel behind the speaker. There are...
The rubber piece may be belong to radiator cap. It became bristle with time, so when you open the radiator cap it break up and drop into radiator. At that instance you didn't pick it out and the...