i had to replace mine a few years ago and i just cut 10mm of the end of the tie rod end.
it works perfectly fine and there was still plenty of hex end on it to put spanner on to
and its far cheaper...
the biggest variable to the question would be the wheel width cause it pays a vial part.
if has been said numerus times but you still havent indicated what width they are.
for example as pop said...
it all depends on what you want out of it.
personally i think its great u want to stick to b series and they have been proven time and time again to be built proof if done right.
but you really...
also with the immobilisers
yes the mongoose may have 3 point system but its up to the installer to decide what 3 points to connect too.
most installers will go for the easiest which is at the...
If you can afford it skunk2 megapower is another good option
I've got them on my bog stock b16 and there awesome
Build quality is excellent and super shiny new
Clearance is awesome too hugs the...
oddessy pc680 is the best batt for its size
for a 5 second draw it will put out over 400 amps which you will never ever even come close to using, its just the nature of the agm dry cell, super high...
have you got the stock water oil cooler from the b18?
if not idd sugest a small 9 row cooler.
dean had problems with his cooler cause it was making his oil too cold with street driving (he fixed by...
You Prob need to disable the vtec spool oil sensor cause ether the sensor or wiring is faulty
The sensor isn't really needed its only a factory safeguard to prevent vtec engaging if for some reason...
For the rear engine bracket u can use one out of a da teg much easier to find
For shift linkage you can ether use your stock one and get it cut down shorter or get a hasport one
Pretty sure the dc2...
There pretty easy to spot in Qld
They ether use the old landcurisers and the camera is on the dash so you have to drive past it before u get caught so if your quick enough to spot them u can get...
For just stock head and block put together and not rebuilding ether
You need b20 block
B16-18 head
Conversion kit with head gasket and oil line
B18 head studs
B18 timing belt and tentioner
B18...
You can just change to a p72 ecu and it won't look for the secondary runners
I've got a stock b16 in my Crx with good headers and exhaust and cold air intake it pops real nice
its also known as alternator whine.
so the faster the alternator spins the louder the whine gets.
its caused by bad grounding or interference getting into the signal cables for the amp or into the...
if your willing to spend more get a good agm battery
means you can relocate to boot later safely
will last 5+ years
has much more cranking power
is a good idea if you have a stereo